RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區

標題: Mini-Z MA010 Low-Down Type Suspension Set [打印本頁]

作者: kayipchan 時間: 2008-9-5 19:19
標題: Mini-Z MA010 Low-Down Type Suspension Set
I bought the Mini-Z MA010 Low-Down Type Suspension Set, however, those spring are shorter than the original spring. If I insert those new and shorter springs, it seems those springs are too short to be functional? Am I supppose to put those spring elsewhere?

http://www.pnracing.us/new/product.php?show=product&id=237

作者: Molala2 時間: 2008-9-5 19:41
These springs are shorter than the original ones so that you can have a lower ride heigh. Therefore, if you use these springs, you need to sand away the proturing sections on the bottom of the chasis, so that they wont be rubing against the carpet/floor.

作者: defcone 時間: 2008-9-5 20:57

原帖由 kayipchan 於 2008-9-5 19:19 發表

 登錄/註冊後可看大圖

I bought the Mini-Z MA010 Low-Down Type Suspension Set, however, those spring are shorter than the original spring. If I insert those new and shorter springs, it seems those springs are too short to ...

You need to put spacers that came with the car onto the pin which is beneath the king pin.

作者: kayipchan 時間: 2008-9-6 01:51
Actually, I am using the metal cover with swing bar now for both front and rear cover, should I add more spacers as well???

Also, where is the proturing sections???

Many thanks

作者: defcone 時間: 2008-9-6 09:55

原帖由 kayipchan 於 2008-9-6 01:51 發表

 登錄/註冊後可看大圖

Actually, I am using the metal cover with swing bar now for both front and rear cover, should I add more spacers as well???

Also, where is the proturing sections???

Many thanks

The pin infront of the one that goes into the toe-in bar.

歡迎光臨 RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區 (https://jk.rc-evo.com/xbbs/)