用電趨向

jj1985 · 發表於 2013-4-4 22:25:58

kevt2005 發表於 2013-4-4 14:18

登錄/註冊後可看大圖

I've been using Ni-Zn batteries for more than a month now. Nominal voltage is 1.6 per cell. Very v ...

Ni-Zn x4 ?

jj1985 · 發表於 2013-4-6 11:14:44

kevt2005 發表於 2013-4-4 22:44
I'm not sure what's your question. I'm using AAA size NiZn batteries. Mini-Z requires 4xAAA.

Thanks C Hing. 咁想再請教一下, MR03可唔可以用到 2S LIPO, 叉滿2粒LIPO電,會唔會燒板?

jj1985 · 發表於 2013-4-7 18:25:23

本帖最後由 jj1985 於 2013-4-7 18:28 編輯

kevt2005 發表於 2013-4-7 15:47
I have not seen LiPo batteries for Mini-Z on the market yet. As far as I know and I've seen, for ...

咁CHING知唔知MR03 Without takiki 塊板最大頂到幾高電壓?用6粒NiHM 得唔得呢?我而家自己改咗,加咗1粒外接電池箱,THX

jj1985 · 發表於 2013-4-8 11:31:21

kevt2005 發表於 2013-4-7 20:09
I have not tested the MR03 board to its limit and so I cannot say what's the actual max voltage th ...

多謝CHING 詳細回覆,又學到野. 不過我英文唔係咁好, 想再確認一下, MR03 可用4粒 NI-ZN 電?
4粒電壓介乎 1.6X4=6.4 至 1.9X4=7.6 之間? 都唔會燒板? 謝謝ching!!!

jj1985 · 發表於 2013-4-9 18:43:24

本帖最後由 jj1985 於 2013-4-9 18:48 編輯

cptkirk9 發表於 2013-4-8 20:25
I think a charge up NiMh battery will be around 1.4-1.5V so that 6x is around 9V max.
For NiZn, 4x1. ...

多謝兩位CHING指教,,真係最後一問...咁買R246 2S LI-FE電好,定4 X NI-ZN 好? R246 要剪位我唔介意...最梗要粒電夠勁...謝謝

問題問多了,請不要介意...謝謝

jj1985 · 發表於 2013-4-9 18:45:04

kevt2005 發表於 2013-4-9 18:04
Sorry, my computer doesn't have chinese character input now. You are correct. I was just trying ...

謝謝CHING指教.

		自動登錄	找回密碼
密碼			新玩家註冊