1. 我係用來叉1排四粒(每粒 800mAh) 的 ATMOIC VP800電, 請問, 我SET 0.8A 叉 有無問題?
OK
2. set 0.4A & 0.9V 放電, 有無問題? OK
3. NiMH CYCLE set - DCHG>CHG 3次, 有無問. This function is to use to refresh or activate the battery. No need to use every time.
4. CAPACITY CUT-OFF 我SET幾多先好 (原廠係SET 5000mAh) If for your 800mah MiMH battery, set 800mah, the max capacity cutoff protection.
5. NiMH Sensitivity D.Peak, 我set 7mV/Cell, 有無問題? Default is 4mV/Cell
6. 當充電果陣, 右下角咪顯示有幾多mA叉咗入啲電池度o既, 因為電池本身係800mAh, 所以想問下, 究竟叉滿果陣, 去到幾多就夠了 (因為我試過破千, 唔知正唔正常, 所以拿拿聲抆咗啲電)
It must be lower than 800mAh, cannot over the battery capacity eg. over 1000mah is danger.
If your battery already has some battery, you only can charge not more than 800maH (max) .......may be 1/3 around 300mAh or 1/2 400mAH
|
