新手一問 - 伺服器抖動

各位好,
最近終於造好了自己的RC船, 不過實走一會後各個CH的伺服器都會有很大幅度的抖動, 特別是油門推近最高的時候
請教各位師兄有甚麼方法可以解決這問題??

路過一問小弟用 FUTABA S3003伺服器在關掉遙控之後,S3003會左左右右跳格自轉 (是否未調較好?)

借樓主MS8850兄小小位

1. Is your RX battery powerful enough ? May be your servo end-point setting is too large --> servo is stalled and cause battery overloaded, and hence battery voltage unstable...

2. I don't know about your TX, but may be your TX can select frame rate (high speed or slow speed), AND assume your servo is Analog servo
ie. If Analog Servo with high speed frame rate, servo will be vibrated.

RGear 發表於 2016-9-27 13:04
1. Is your RX battery powerful enough ? May be your servo end-point setting is too large --> servo i ...

感謝解答, 我再研究看看!

2. I don't know about your TX, but may be your TX can select frame rate (high speed or slow speed), AND assume your servo is Analog servo
ie. If Analog Servo with high speed frame rate, servo will be vibrated.

RGear hing , THANKS.

ms8850 發表於 2016-9-27 17:37
感謝解答, 我再研究看看!

請見諒因為早前都有ms8850兄屬於同一部件(伺服器安裝及使用)問題出現

又唔想浪費論壇資源或重復請多多包函

the problem is 2.4g transmitter. that must change fm transmitter