My Physics final project (custom puller)

Just noticed that I accidentally made the wheelbase perfect for 1/10 MAXX bodies

原帖由 Jackson 於 2006-5-15 11:00 發表
Another update!

Qualifying is on the coming Wednesday. This is where most of the marks are given. Competition is on the coming Friday. The event is going to be broadcast live on the internet. I  ...

Good work buddy, very nice !!  

V3 is finally done after about 14 hours of work...why V3? Because V2 was destroyed by one of my group members while full throttling into a curb

Anyways, here is the link to tomorrow's competition.
http://msl.stream.yorku.ca/media ... -145d-4a72024622s4.

Oh yes...and V3...

                               
登錄/註冊後可看大圖

Time for the competition is 8:30AM to 1:30PM. I think we are in GMT.
Comp is in an hour!!!

原帖由 Jackson 於 2006-5-19 12:21 發表
Time for the competition is 8:30AM to 1:30PM. I think we are in GMT.
Comp is in an hour!!!

nice! the new acrylic side plates will they hold? but the longer chassis/wheelbase willl mean it won't wheelie as much

good luck man!

The inner plates are acrylic, the outer reinforcements are lexan. The car was very strong today, quite a few hits, but plates were fine. We won 1st in speed, 3rd in climbing. But the climbing killed my axle. I had used JBWeld 2 times for this project and at both times it failed. This time the axles were freespinning due to it's failure So basically, we had no power for tug-o-war...my favourite event! And we didn't get to participate!!!

No more JBWeld Products for me

原帖由 Jackson 於 2006-5-19 14:03 發表
Oh yes...and V3...

                               
登錄/註冊後可看大圖

Good brother, very nice, what shell U are going to put on top??  A truckie shell ??  

Remember to post some pics of the competition, thanks mate ...