RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區

標題: INTEGY OCTANE-2 DISCHARGER 可以 discharger stick pack 吗？ [打印本頁]

作者: beaim 時間: 2008-12-25 21:15
標題: INTEGY OCTANE-2 DISCHARGER 可以 discharger stick pack 吗？
请问师兄， 6个头接连晒，可以 discharger stick pack 吗？

[ 本帖最後由 beaim 於 2008-12-25 21:28 編輯 ]

: 登錄/註冊後可看大圖

作者: beaim 時間: 2008-12-25 21:16
再用这个balance 翻。

因为 muchmore 3 A 很慢。

: 登錄/註冊後可看大圖

作者: Xraylover 時間: 2008-12-25 22:02
no

作者: beaim 時間: 2008-12-25 23:31

原帖由 Xraylover 於 2008-12-25 22:02 發表

 登錄/註冊後可看大圖

no

有没办法？

作者: Xraylover 時間: 2008-12-26 14:13
use 12V light pulb discharge and then use your much more law
but pay attention to avoid overdischarge by the light pulb.....

作者: beaim 時間: 2008-12-26 14:58

原帖由 Xraylover 於 2008-12-26 14:13 發表

 登錄/註冊後可看大圖

use 12V light pulb discharge and then use your much more law
but pay attention to avoid overdischarge by the light pulb.....

brother, dun play me la.

12v light pulb can eat how much amp.

both thing is mine..

作者: Xraylover 時間: 2008-12-26 16:18
ha...I advise u to check check the power of 12V light pulb

ley say, u get an 100W light pulb....I think at least the 12V light pulb will draw around 10A...

if 10A is not enough, then u use 2 light pulbs in parallel....

again, please be careful to overdischarge....

作者: beaim 時間: 2008-12-26 16:34

原帖由 Xraylover 於 2008-12-26 16:18 發表

 登錄/註冊後可看大圖

ha...I advise u to check check the power of 12V light pulb

ley say, u get an 100W light pulb....I think at least the 12V light pulb will draw around 10A...

if 10A is not enough, then u use 2 lig ...

thanks bro, will try try.

歡迎光臨 RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區 (https://jk.rc-evo.com/xbbs/)