RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區

標題: ｔａｍｉｙａ　959齒比一問! [打印本頁]

作者: calvinpun2000 時間: 2006-5-25 17:54
標題: ｔａｍｉｙａ　959齒比一問!
use 原裝大齒 useTamiya RX-540VZ R/C MOTOR !!!use how　ｍａｎｙ　摩打齒？？？ｔｈｘ！

作者: calvinpun2000 時間: 2006-5-25 20:52
any people　ｋｎｏｗ？？？

作者: peter7 時間: 2006-5-25 21:03
16T motor pinion with 41T drive gear

作者: calvinpun2000 時間: 2006-5-25 21:13
THX

作者: calvinpun2000 時間: 2006-5-25 21:17
I F USE 23T MOTOR???

作者: minimini 時間: 2006-5-25 23:42

原帖由 peter7 於 2006-5-25 21:03 發表
16T motor pinion with 41T drive gear

this gear ratio will have higher torque.......as far as I can remember......it can use 18T pinion also.....forgot the big gear.......that will have higher speed.......

作者: 維園船王 時間: 2006-5-26 22:19

原帖由 minimini 於 2006-5-25 23:42 發表

this gear ratio will have higher torque.......as far as I can remember......it can use 18T pinion also.....forgot the big gear.......that will have higher speed.......

快d切個VZ落部車度,跟手影張相泥睇下la~~

作者: minimini 時間: 2006-5-26 23:18

原帖由 維園船王 於 2006-5-26 22:19 發表

快d切個VZ落部車度,跟手影張相泥睇下la~~

OK.....

作者: calvinpun2000 時間: 2006-5-27 13:27
徵緊vz

作者: calvinpun2000 時間: 2006-5-27 14:03
959一定要用Tamiya RX-540VZ R/C MOTOR?????

作者: peter7 時間: 2006-5-27 14:30
Let me explain again. In 959, you can not adjust the position of the motor. So gear ratio is not depends on what motor you use. It depends on which drive gear you use. The 959 comes with two drive gear. 41T or 40T. Use 18T motor gear for 40T drive gear and use 16T for 41T drive gear. The 959 can use motor with design similar to RX-540VZ Tecnigold motor.

作者: calvinpun2000 時間: 2006-5-27 14:34
thX!

歡迎光臨 RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區 (https://jk.rc-evo.com/xbbs/)