RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區

標題: 問下大家set車既問題 [打印本頁]

作者: matthew0731 時間: 2009-4-5 19:26
標題: 問下大家set車既問題
各位車友
你地都係由原裝車改車
但在你們換零件後會唔會慢慢set好晒所有野@@?
例如直線,過灣,速度等等
因為小弟換左零件後要好長時間先set返好架車..咁係正常定唔正常
依嫁最大煩惱係行直線各過灣方面既問題
行直路都會打白鴿轉...過灣更加唔洗問

作者: netherlkm 時間: 2009-4-5 20:09
要視乎是02或awd
通常是珠差，其他的要試先知

作者: billy86che 時間: 2009-4-6 10:18
本帖最後由 billy86che 於 2009-4-6 10:29 編輯

Relying only on "trial and error" without obtaining background knowledge takes ages to set up a car. Even if you finally succeed, it will be fragile against slight changes of the track and the difficulty in maintenance and then you will have to start it all over.

Advice 1: Reading makes life a lot easier.

Advice 2: Take your car to the pros at the tracks.

作者: kelvin1024 時間: 2009-4-6 10:34
I got that problem b4 , that may caused by tire too hard , remote trim problem and ball different problem ! but most problem was caused by tire ! so far we use 20 degree tire could prevent the 打白鴿轉 problem !

作者: natnatbobo 時間: 2009-4-6 11:27

各位車友
你地都係由原裝車改車
但在你們換零件後會唔會慢慢set好晒所有野@@?
例如直線,過灣,速度等等
因為小弟換左零件後要好長時間先set返好架車..咁係正常定唔正常
依嫁最大煩惱係行直線各過灣方面既問題
行 ...
matthew0731 發表於 2009-4-5 19:26

登錄/註冊後可看大圖

of course it takes time to set (and depends on your own), u need to try and try...spring, swing shaft, knuckle, front sterring plate, rear toe bar, one way/ball-diff., car height, shell, tire, control setting, different track......GOOD LUCK

作者: ganboy 時間: 2009-4-6 12:38
本帖最後由 ganboy 於 2009-4-6 12:40 編輯

其他setting唔好講住, 最基本要搵0岩套呔, 差速要set得好, 車架零件各樣要正型順暢, AWD suspension 要加返0的油, 唔會行唔直0既...

歡迎光臨 RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區 (https://jk.rc-evo.com/xbbs/)