RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區

標題: 3S1P A123 電 [打印本頁]

作者: rcray    時間: 2009-4-20 02:57
標題: 3S1P A123 電
3S1P A123 電

玩完後:
Cell 1: 3.2v
Cell 2: 3.2v
Cell 3: 0.4v (有D熱)

請問係唔係cell 3 死左?

thx!
作者: moto123    時間: 2009-4-20 07:02
Try to charge it in parallel charger mode, it is much better.

The cell may not die, try to recycle it few times
作者: rcray    時間: 2009-4-20 07:43
yup.
the cell get back to 3.3v after rechaging it alone.
but it seems that the volume of this cell is smaller than other two....
作者: gordonleung    時間: 2009-5-2 02:39
如果可以平衡差, 我建議你單獨差呢粒電到大約1700左右, 然後再平衡差排電.
如果冇, 咁就為有逐粒差番滿, check 下每粒電既電壓, 如正常的話, 下次玩完再check未差之前再check一次電壓, 睇下粒電係咪正常.




歡迎光臨 RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區 (https://jk.rc-evo.com/xbbs/) Powered by Discuz! X3.2