標題: Engine Temperature [打印本頁] 作者: st_kuen 時間: 2009-6-6 01:36 標題: Engine Temperature C-hings,
May I ask what the normal temperature range for the Engine work?
My Engine temperature is around 210 degree, is it too high?
Thanks!作者: skeung 時間: 2009-6-6 01:46
120都已經算係高架喇作者: Edwin 時間: 2009-6-6 02:09
210? What engine do you run?作者: edmondhk 時間: 2009-6-6 02:36
210F ma....
係C就爆左
210F=98.XC
都算正常作者: st_kuen 時間: 2009-6-6 03:02
Sorry! C-hing, It should be 210F!
Thanks all c-hings for your kind advices!!作者: st_kuen 時間: 2009-6-6 03:04
Then, what is the max. temperature we should not exceed?作者: junk18740 時間: 2009-6-6 03:16
for me... any higher than 138C will do more harm than reformance...作者: jf813 時間: 2009-6-6 09:45
For .21 around 120, .12 slighly higher around 120-130 this is the usual working temperature. Don't go over 150 and it should be ok.作者: swswsw 時間: 2009-6-6 10:07
353 09' 115 c measured on glow plug, around 125 c measured on case exhaust area.
OS spec II 105c measure on glow plug; Both measured at the end of run, beginning temp around 10 c lower.作者: michaelcheung 時間: 2009-6-6 10:24
ENGINE 頂溫度唔過120度就OK作者: st_kuen 時間: 2009-6-6 13:55
Thank all c-hings for the kind help!!作者: tekin 時間: 2009-6-6 14:06
not more 120度 and "engine sound" is important too...作者: shanfung700 時間: 2009-6-6 23:52
If we we we sing without enough smoke, becareful the chicken leg la..................作者: pcb6827 時間: 2009-6-13 20:49
可以滴水试吗作者: BeLeBaLa 時間: 2009-6-19 22:16
210 is C or F degree?作者: 赤目軍馬 時間: 2009-6-20 01:40
不看温度,看有沒有白龍(煙)
温度計是事後,有煙是事前。作者: st_kuen 時間: 2009-6-20 15:02
赤目c-hing,
You mean the 白龍(煙) in the glow plug area or in the ENGINE 頂?
With 白龍(煙) = overheat?
Thanks!作者: maxchow 時間: 2009-6-20 15:39
.12 120 C 應已是最高溫了~
target 保持 100 C 倒我覺得安全,
因為有時 set lim 左少少玩完返來都唔會咁易 over 120C。作者: orochichu 時間: 2009-6-21 16:06 本帖最後由 orochichu 於 2009-6-21 16:09 編輯