標題: Digital servo [打印本頁] 作者: st_kuen 時間: 2009-7-8 08:26 標題: Digital servo Any C-hing can tell me which of the followings belong to digital servo?
1) KO PS-712 FET
2) Sanwa ERG-VS
3) Sanwa ERG-RZ
4) TowerPro MG 995
Thanks in advance作者: [email protected]時間: 2009-7-8 08:29
all is not digital servo作者: st_kuen 時間: 2009-7-8 08:41
Can I set the Frame rate to 5.5ms(for digital servos) in my DX3R with these servos?
The servos seem ok and will not move erraticlly when I set the response rate in 5.5ms.
Should I lower the Frame rate to 11ms?
Thanks!作者: volvo9 時間: 2009-7-8 10:04
You should select the Frame rate to 11ms or 16.5ms, if your servo is no digtal type.作者: st_kuen 時間: 2009-7-9 10:01
Thanks! C-hings!作者: law123 時間: 2009-7-9 18:33
想問下各位通常油車2個servo是否一般都用同一個呢?作者: st_kuen 時間: 2009-7-9 18:59
Should be different as two servos have different requirement!作者: law123 時間: 2009-7-10 08:57
那通常油門的servo要有咩特點才好呢?
