RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區

標題: [help] Overland 爛左 [打印本頁]

作者: alangor 時間: 2006-7-5 21:17
標題: [help] Overland 爛左
請問各位師兄，有冇得買parts replace番爛左個度(車尾懸掛）?

有冇alloy 件replace?

Thanks

作者: Colin 時間: 2006-7-5 21:26
用aa膠頂住先得唔得?

作者: alangor 時間: 2006-7-5 21:29
已經黐左兩次

作者: 雷公 時間: 2006-7-5 21:31

原帖由 alangor 於 2006-7-5 21:29 發表
已經黐左兩次

use thin metal wire, drill some holes, affix the broken part in position, tie and done!

作者: mikewu 時間: 2006-7-6 10:32

原帖由雷公於 2006-7-5 21:31 發表

use thin metal wire, drill some holes, affix the broken part in position, tie and done!

Or you can go to GPM for some metal parts.
The part you damage is very easy to break so better just go GPM for a metal one.. but prices are a little expensive.....

作者: mikewu 時間: 2006-7-6 10:35

原帖由 mikewu 於 2006-7-6 10:32 發表

Or you can go to GPM for some metal parts.
The part you damage is very easy to break so better just go GPM for a metal one.. but prices are a little expensive.....

Oh wait.. looking at your photo again, it's the bottom of the car... That piece might not have alloy parts.... either get factory plastic replacement or DIY to fix it..... Sorry can't help you...
But do check GPM as they have some metal parts for this little truck.. and PLEASE, DON'T JUMP TOO HIGH WITH OVERLANDS!!!

作者: alangor 時間: 2006-7-6 20:10
hehee^^ thanks all ar
tomorrow i'll go to KWS and see see have this metal part or not

really thank you very much^^

歡迎光臨 RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區 (https://jk.rc-evo.com/xbbs/)