RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區

標題: c hing 有無玩緊 Novak HV Pro System Set / Hobby Wing 好盈 150A Set [打印本頁]

作者: chacha 時間: 2009-12-9 10:28
標題: c hing 有無玩緊 Novak HV Pro System Set / Hobby Wing 好盈 150A Set
本帖最後由 chacha 於 2009-12-9 11:12 編輯

c hing有無玩緊 Novak HV Pro System Set/ Hobby Wing 好盈 150A Set / 有感摩打

請問哪一個套裝電子變速比較合適 E-Maxx 如果原裝摩打齒,哪一個套裝比較好, 有無年代分別(如何分別年代) 優點??列舉細節謝謝! 現時購買哪一個比較好, 唔該晒!

Novak
HV Pro Brushless System 4.5T with 5mm Rotor (Kv=5,000; Watts=890)
HV Pro Brushless System 5.5T with 5mm Rotor (Kv=3,700; Watts=800)
HV Pro Brushless System 6.5T with 5mm Rotor (Kv=3,400; Watts=730)
HV Pro Brushless System 7.5T with 5mm Rotor

登錄/註冊後可看大圖

Hobby Wing 好盈
EZRUN-150A-SD Brushless ESC for 1/5 Car (Competition Race)

登錄/註冊後可看大圖

Output: Continuous current 150A, burst current 1080A.
Input: 6-18 cells NiMH/NiCd or 2-6 cells LiPo.
BEC Output: 5.75V/3A (Switch mode built-in BEC).
Resistance: 0.0002 Ohm.
Motor Supported: Sensorless and sensored brushless motors
Suitable Brushless Motor: 6T and > 6T
Suitable Car:  1/5 on-road or off-road cars / trucks for competitive race.
Size: 68mm(L) * 55mm(W) * 45mm(H).
Weight: 150g(Without wires)

登錄/註冊後可看大圖

Output: Continuous current 150A, burst current 950A.
Input: 6-18 cells NiMH/NiCd or 2-6 cells LiPo.
BEC Output: 5.75V/3A .
Resistance: 0.0002 Ohm.
Motor Supported: Sensorless and sensored brushless motors
Suitable Brushless Motor: 4.5TT and > 6T
4.5T以上（含4.5T），KV<=3000 （4 cells LiPo）；
                            6T以上（含6T），KV<=2400 （6 cells LiPo）
Suitable Car:  1/8 on-road or off-road cars / trucks for competitive race.
Size: 58mm(L) * 46.5mm(W) * 35mm(H).
Weight: 150g(Without wires)

摩打

登錄/註冊後可看大圖

XERUN-4274SL
2250KV
Diameter:42.0mm
Length mm (Without Shaft): 74mm
Shaft: 5mm
Shaft Length: 18.5mm
Weight: 385g

作者: kingman7788 時間: 2009-12-9 10:38
好就更係novak好，不過你簡得novak又唔介意有冇感的話，仲有其他選擇: Tekin , Mamba monster, Xerlorin都係好野~
我以前用novak HV pro 4.5r +原裝齒比結果溶電線燒電變

不過行洛好crazy下

作者: hardmankam 時間: 2009-12-9 11:40
For Monster trucks, you should consider Mamba Monster or Tekin system. Choose a 1750kv range BL and run 6S Lipo. Low KV @ High Voltage is more efficient, so less heat and stress on motor and ESC.

作者: powis 時間: 2009-12-9 11:53
if you can affort to buy novak system, i really suggest to pay a bit more to buy Mamba Monster or Tekin. I have a bad experience and feeling on Novak system now as i have an experience on burning ESC and always heard that it is easy to stop to operate due to over heat or some other reasons. Again, just my personal opinion.

作者: hardmankam 時間: 2009-12-9 12:15
From western sites, they actually like the HobbyWing 150A esc. I am using one and is working very well. It is the cheapest 1/8 ESC on the market right now. However, Hobbywing's motor is not very good. They are very hot and the rotor may break apart.

歡迎光臨 RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區 (https://jk.rc-evo.com/xbbs/)