RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區

標題: 瘋了才這麼搞之雙星M-04 GT [打印本頁]

作者: aydinkao 時間: 2009-12-10 12:56
標題: 瘋了才這麼搞之雙星M-04 GT
本帖最後由 aydinkao 於 2009-12-10 13:12 編輯

不知有無先進如此搞過？
M-03可以變身FF-02，那M-04可以放大變成MR房車嗎？
在這樣得疑問下動手改了M-04.....
M-04M軸距原來是225mm，加延長件可以到239-240mm，
那再加一件應該可以到254-255mm，不就可以裝房車殼了！
實際加了延長件、TL-01擺臂、TOE-IN座之後，拿尺一量軸距竟是251mm左右。
一開始有些沮喪，畢竟一般260mm車殼不能裝了；
但市場不是沒有251mm的車殼，那就是雙星的Z4、911GT3。
忍痛去敗了個Z4車殼，回來一合車寬軸距都剛剛好。
實際去跑這個沒殼的M-04 GT，車性並不瘋呀，而且是在公園的瓷磚地上；當然馬達弱、101BK也是好操控的原因之一啦。

作者: littlekid626 時間: 2009-12-10 13:06
呼~ 好久沒來留言.....

幹的不錯! 終於看到跟我一樣瘋二驅的人了! 改天再把我最近搞的kyosho前驅油車PO上來好了

作者: UKman 時間: 2009-12-10 13:24
聰明得很,一定有玩,祝成功及好灣

作者: jypepe 時間: 2009-12-10 13:46
......如果我一開始懂得可以這樣做...我不會買103GT了....

作者: Bridgestone22 時間: 2009-12-10 14:24
Will you change to a fast motor and test the car handling again?

作者: SamsonSung 時間: 2009-12-10 16:16
Try foam tire, just like 1/12 use foam to run.

作者: aydinkao 時間: 2009-12-10 17:43
F103GT仍算是好車，但車寬好窄...
change to a fast motor = I will try and I think that on high grip circuit Fast Motor will working well.
Try foam tire = Good idea ！ But using stander foam tire will cause narrow track (maybe only 180mm wide totaly). Using Kawahara extra offset foam tire , this car maybe reach 195mm-200mm wide. So I can use 911GT3 bodyshall.

作者: ryancmlam 時間: 2009-12-11 00:07
bro,
1. Have you tried to reverse the rear arm? It might let you get a wheel base of 255mm
2. This configuration likes a rear drive TL01

作者: qoo5qoo 時間: 2009-12-11 00:34
厲害厲害~

作者: aydinkao 時間: 2009-12-11 18:22

bro,
1. Have you tried to reverse the rear arm? It might let you get a wheel base of 255mm
2. This configuration likes a rear drive TL01
ryancmlam 發表於 2009-12-11 00:07

登錄/註冊後可看大圖

Have you tried to reverse the rear arm? = Yes, i tried. but rear sus linkage and shock position become weird, so I give up.

This configuration likes a rear drive TL01 = that is really . But I think M-04 save some weight .

作者: ryancmlam 時間: 2009-12-11 18:47
hi, regarding the possibility of revesing the rear arm, whatif install the sus links and shock on other side to suit the alignment ?

歡迎光臨 RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區 (https://jk.rc-evo.com/xbbs/)