RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區

標題: Virtual RC Racing game 安裝一問... [打印本頁]

作者: lung1 時間: 2009-12-18 20:42
標題: Virtual RC Racing game 安裝一問...
本帖最後由 lung1 於 2009-12-18 20:48 編輯

我岩岩係車中樂買左個VRC 既usb adapter, 買個時跟左隻碟..
襟我返到去裝既時候發覺完全無反應... 佢跟黎個隻碟又開唔到.....
請問有用過既玩家知道係咩問題...?

有無插錯..?

: 登錄/註冊後可看大圖

: 登錄/註冊後可看大圖

作者: lung1 時間: 2009-12-18 20:52
簡邊個先岩...?

: 登錄/註冊後可看大圖

作者: 145240370 時間: 2009-12-18 21:18
想借問聲,買左幾銀呀？

作者: Racon 時間: 2009-12-18 21:37
果接收有冇比電?

作者: lung1 時間: 2009-12-18 21:43

果接收有冇比電?
Racon 發表於 18/12/2009 21:37

登錄/註冊後可看大圖

係usb到拎電...

作者: kkchung 時間: 2009-12-18 21:45

簡邊個先岩...?
lung1 發表於 2009-12-18 20:52

登錄/註冊後可看大圖

先去控制台設好你的遙控器中位, VRC那邊設VRC USB controller便可.

: 登錄/註冊後可看大圖

: 登錄/註冊後可看大圖

: 登錄/註冊後可看大圖

: 登錄/註冊後可看大圖

作者: lung1 時間: 2009-12-18 21:49
頭先我都去到呢個畫面, 但淨係轉一面先有反應, 油門完全無反應...
其實我有無插錯到d線..?

: 登錄/註冊後可看大圖

作者: lung1 時間: 2009-12-18 21:54
去到呢個畫面應該要點做...?

: 登錄/註冊後可看大圖

作者: 衫魚仔 時間: 2009-12-18 21:55
嘩......日日係屋企練車~?

作者: kkchung 時間: 2009-12-18 21:55

頭先我都去到呢個畫面, 但淨係轉一面先有反應, 油門完全無反應...
其實我有無插錯到d線..?
lung1 發表於 2009-12-18 21:49

登錄/註冊後可看大圖

: 登錄/註冊後可看大圖

: 登錄/註冊後可看大圖

作者: kkchung 時間: 2009-12-18 21:57

去到呢個畫面應該要點做...?
lung1 發表於 2009-12-18 21:54

登錄/註冊後可看大圖

發射(左右前後),下一步>下一步>下一步>完成.

作者: lung1 時間: 2009-12-18 21:59

發射(左右前後),下一步>下一步>下一步>完成.
kkchung 發表於 18/12/2009 21:57

登錄/註冊後可看大圖

左右前後個十字都無反應bor....

作者: kkchung 時間: 2009-12-18 22:06

左右前後個十字都無反應bor....
lung1 發表於 2009-12-18 21:59

登錄/註冊後可看大圖

十字能否回到方格中?2.4G是否之前已對好頻?

作者: lung1 時間: 2009-12-18 22:07

十字能否回到方格中?2.4G是否之前已對好頻?
kkchung 發表於 18/12/2009 22:06

登錄/註冊後可看大圖

個十字不能回到方格中, 同埋係完全無反應...
隻接收著左綠燈應該已對好左~

作者: kkchung 時間: 2009-12-18 22:12

個十字不能回到方格中, 同埋係完全無反應...
隻接收著左綠燈應該已對好左~
lung1 發表於 2009-12-18 22:07

登錄/註冊後可看大圖

USB放在其他控和接收能否正常, 之前聽過用在少數形號2.4G會不正常.

作者: lung1 時間: 2009-12-18 22:15

USB放在其他控和接收能否正常, 之前聽過用在少數形號2.4G會不正常.
kkchung 發表於 18/12/2009 22:12

登錄/註冊後可看大圖

屋企得一支控, 試唔到...
4PK 能正常使用嗎?

作者: kkchung 時間: 2009-12-18 22:15
Control VRC with your own transmitter, it can't get any more realistic than that. All the settings you make on your transmitter, like trims, exponential steering and brake settings will directly be noticable in VRC.

The VRC-3 USB adaptor works independent of the brand or frequency of your transmitter as it only uses the standardized servo output signals and translates these to the standardized game controller input using the HID protocol, although the modulation does have an effect.

Spektrum 2.4 GHz systems with receivers SR3100 and SR3520 are supported and work excellent in all 5.5-11-16.5ms modes.

Futaba 2.4 Ghz systems are NOT supported because of the different modultation although some VRC users have found work-arounds to make it work. We advise to purchase the VRC-2 USB adaptor to work with 2.4 GHz systems.

The VRC-3 works on all 27-40-53-72 MHz.
With Futaba only FM and PPM modes can be used. PCM and HRS modes are not supported.

Your receiver is powered through the VRC-3 USB adaptor which receives its power from the USB port of your computer. Do not connect a receiver battery pack.

作者: lung1 時間: 2009-12-18 22:57

Control VRC with your own transmitter, it can't get any more realistic than that. All the settings you make on your transmitter, like trims, exponential steering and brake settings will directly be no ...
kkchung 發表於 18/12/2009 22:15

登錄/註冊後可看大圖

岩岩用第二部電腦試過都係襟....睇黎要換過支控....

作者: defcone 時間: 2009-12-23 00:24
"Futaba 2.4 Ghz systems are NOT supported because of the different modultation although some VRC users have found work-arounds to make it work. We advise to purchase the VRC-2 USB adaptor to work with 2.4 GHz systems."

我都買左, 佢做緊promotion$10USD, $14USD寄到黎好似.

歡迎光臨 RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區 (https://jk.rc-evo.com/xbbs/)