RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區
標題: Modified Tamiya TA05MS & 416WE [打印本頁]
作者: yokomo 時間: 2010-1-25 23:34
標題: Modified Tamiya TA05MS & 416WE
本帖最後由 yokomo 於 2010-1-28 23:31 編輯
Newly build Tamiya 416WE, The ESC has been put on battery side.
Any comment on electronic items layout?
Thanks All !!
-
-
作者: RANKS 時間: 2010-1-25 23:45
本帖最後由 RANKS 於 2010-1-25 23:48 編輯
put more weight to the front will make car more easy to drive
作者: yokomo 時間: 2010-1-25 23:49
Yes, the ESC is Tekin R1 Pro.
作者: console001 時間: 2010-1-26 01:19
why put the esc on rear right side ? for balancing ?
作者: bravohk 時間: 2010-1-26 01:37
esc和鋰電都會發熱, 點解唔改receiver?
作者: minimini 時間: 2010-1-26 01:52
woooo...........水晶邊...........good !!............
作者: hk_sdu 時間: 2010-1-26 02:02
ok wor, good try, how is the left right balance without adding weight?
作者: yokomo 時間: 2010-1-26 09:08
So sorry, I don't have the equipment to check whether the left & right sides can be balanced. So I try to ask whether any brother has tried this idea before & got experience to share.
Thanks All !!
作者: yokomo 時間: 2010-1-26 09:11
5# bravohk
Since the ESC is heavier than the Rx, so I tired this layout.
作者: yokomo 時間: 2010-1-26 09:14
4# console001
Right, the idea is for balancing. However, the size & shape of ESC & battery should be considered.
作者: Bridgestone22 時間: 2010-1-26 10:21
Good idea!
作者: hk_sdu 時間: 2010-1-26 11:19
8# yokomo
A cheap way is to use 2 screws to put on the button central holes of your chassis.
作者: yokomo 時間: 2010-1-26 11:25
Do u know how much of the tool for checking balance from Hudy?
Thanks All !!
作者: hk_sdu 時間: 2010-1-26 11:43
Atomic is around or below $100. hudy last time i saw it in "red star", if i remember correctly $100 each, so $200 total.
Very expensive for just a small piece of tool
作者: yokomo 時間: 2010-1-26 11:58
So I will try yr method to use two pcs of screw 1st....
作者: console001 時間: 2010-1-27 00:10
上個月在KWS 見到 HUDY chassis balancing tool, under $90~
用過覺得可當一個粗略估算,但應不算很精準, 因有時兩邊"差不多"時也可刻意令佢平衡地放係支釘上面...
所以後來又買左4個電子磅, 問題更大(但係該係好既方向), 因放磅個平面水唔水平,夠唔夠硬都好有影響, 如果係一般檯面, 只要隻手按下一邊檯面都會影響個讀數......用hudy的 set 車板又要先搞好個水平(仲未得閒搞)...
我都希望可以慢慢試下balance的東西, 因在hudy set車書中都冇詳細講呢樣野...
c hing有物新發現記得post出來交流下~
作者: console001 時間: 2010-1-27 00:20
我打算下一步係架t3既底板度鑽多幾個孔, 試下度前後左右的balance...
或者更加理想整個行啤令的平台(有d似Tweak Station個概念...), 咁好似都唔錯...
又或者將4支balance釘裝在4個輪下度電子磅...
但也發現裝了避震是度唔到真實的weight balance, 唔知對不對~
作者: yokomo 時間: 2010-1-27 09:45
Thanks again for yr suggestion & glad to exchange ideas of RC here.
actually, I want to try electronic balances method too. Please kindly advise what brand & capacity of electronic balances are being used.
作者: mattfok 時間: 2010-1-27 13:37
This's so Good
作者: console001 時間: 2010-1-27 21:35
有人一齊試呢樣野真係好玩呢!
我買左呢隻pocket scale, 特價中約$94一隻,(500g/0.1g increasing) :
