RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區

標題: MR-03 問題 [打印本頁]

作者: kelvin1024 時間: 2010-2-22 23:11
標題: MR-03 問題
最近想上返車埸玩車,想話買多部03 , 唔知CT 同MMS 多唔多ching玩03?
因為唔想菬fet用AD向03又得唔得?
Gyro 用老番o唔ok呢?Thx!

作者: 800mah 時間: 2010-2-22 23:34
1) MMS 好多人玩, 基本上大部份都係 03
2) NO fet 用 AD 無問題, 好多人都係咁
3) Gyro 好少人用.

作者: d.s 時間: 2010-2-23 01:01

1) MMS 好多人玩, 基本上大部份都係 03
2) NO fet 用 AD 無問題, 好多人都係咁
3) Gyro 好少人用.
800mah 發表於 2010-2-22 23:34

登錄/註冊後可看大圖

多口問句,800mah師兄有冇親身購入或使用過gyro??

作者: 800mah 時間: 2010-2-23 01:06

多口問句,800mah師兄有冇親身購入或使用過gyro??
d.s 發表於 2010-2-23 01:01

登錄/註冊後可看大圖

有呀~　借人地o既黎用

作者: d.s 時間: 2010-2-23 01:20

有呀~　借人地o既黎用
800mah 發表於 2010-2-23 01:06

登錄/註冊後可看大圖

感覺如何?

作者: 800mah 時間: 2010-2-23 11:44
tried it on dNano, feels great, helped a lot in preventing the car from loosing control.

but i always prefer hard-setup the car, rather than soft-setup

作者: kelvin1024 時間: 2010-2-23 17:00
有無comment for "Gyro" copy cat 理論上IC program 照copy 應該一樣?!
事關整果部都幾貴想省得就省
Classics Set 980
Kysoho ball diff 240
ATM chacha 240
KM metal real body kits 150
ATM bearing 60
Tires 50
Gyro copy cat 180
T parts 70
PN motor Gear 50
***Optional parts***
Fast motor 240
FET 240
Total $2500

作者: 800mah 時間: 2010-2-23 17:16
ARTR Set with body $998
3Racing ball diff $98 (comes with non-magnetic shaft)
Motor mount & Disc Damper >> go for PN racing
T plate >> ATM 7.5mm "blue" t-plate $35
motor gear >> just use original, better tha metal.
Fast motor >> ATM AD stock ($16X @ MMS)

you will also need:
stainless king pin ball >> PN racing $40
spring set (short) >> PN racing $55

作者: d.s 時間: 2010-2-23 22:49
本帖最後由 d.s 於 2010-2-23 22:51 編輯

tried it on dNano, feels great, helped a lot in preventing the car from loosing control.

but i always prefer hard-setup the car, rather than soft-setup
800mah 發表於 2010-2-23 11:44

登錄/註冊後可看大圖

有否試過用於MR03??

作者: 800mah 時間: 2010-2-24 00:17

有否試過用於MR03??
d.s 發表於 2010-2-23 22:49

登錄/註冊後可看大圖

just say whatever u want about a gyro instead of keep on asking.

作者: natnatbobo 時間: 2010-2-24 00:26
i used gyro for a while, i found going straight is definitely not a problem, but turning is shxxxt, how can i rectify it ??? thx...

作者: 800mah 時間: 2010-2-24 00:33

i used gyro for a while, i found going straight is definitely not a problem, but turning is shxxxt, how can i rectify it ??? thx...
natnatbobo 發表於 2010-2-24 00:26

登錄/註冊後可看大圖

you can adjust the gyro response, lower it through the ICS

then u can setup the car again to run fast, turn fast, then lower the gyro response again...

until you don't need the gyro anymore.

作者: natnatbobo 時間: 2010-2-24 00:37
12# 800mah

c Hing, which part in the ICS ??? lower the figure at ST gain ???

作者: 800mah 時間: 2010-2-24 00:46

12# 800mah

c Hing, which part in the ICS ??? lower the figure at ST gain ???
natnatbobo 發表於 2010-2-24 00:37

登錄/註冊後可看大圖

the last two.
one slows down the car while the other auto steers.

作者: natnatbobo 時間: 2010-2-24 00:54
14# 800mah

thx C Hing, that means lower the "ST gain" will turn better and add the value at "TH gain" will make the car faster, right ???

作者: 800mah 時間: 2010-2-24 01:13

14# 800mah

thx C Hing, that means lower the "ST gain" will turn better and add the value at "TH gain" will make the car faster, right ???
natnatbobo 發表於 2010-2-24 00:54

登錄/註冊後可看大圖

one is how much the will auto steer in order to correct "mistakes" sensed by the gyro
the other one is how much the car will slow down during the above auto steer

both work together, if there's no need to auto steer, the car will not slow down

歡迎光臨 RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區 (https://jk.rc-evo.com/xbbs/)