RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區

標題: 最理想O既頭尾DROP 會係幾多呢? [打印本頁]

作者: yc854 時間: 2010-4-29 15:57
標題: 最理想O既頭尾DROP 會係幾多呢?
最理想O既頭尾DROP 會係幾多呢?

作者: Marco明 時間: 2010-4-29 16:02
最理想係根據唔同場地.....唔同車架特性.....再去調整出黎既setting

作者: 師兄 時間: 2010-4-29 16:23
front 2mm
rear 3mm

作者: hk_sdu 時間: 2010-4-29 16:56
see this, most touring car has similair setup, on downstop, camber, toe
http://bbs.rc-evo.com/viewthread ... &extra=page%3D1

Don't know car u are using, try to start with F downstop 6mm, R downstop 5mm. Same as T2 or T2 intial setting. Adjust from here. There is no such thing as 最理想. The best for everyone, every car and every track is different.

作者: Marco明 時間: 2010-4-29 17:28

see this, most touring car has similair setup, on downstop, camber, toe

Don't know car u are us ...
hk_sdu 發表於 2010-4-29 16:56

登錄/註冊後可看大圖

6.5mm係指ride height嗎???

作者: chiuxxc 時間: 2010-4-29 20:51
downstop!量度未端下搖臂至底板底部的高度

作者: hk_sdu 時間: 2010-4-30 11:40
本帖最後由 hk_sdu 於 2010-4-30 11:42 編輯

6.5mm係指ride height嗎???
Marco明發表於 2010-4-29 17:28

登錄/註冊後可看大圖

As chiuxxxc said, it is downstop. On the TOP setup sheet, ride hight for F and R is 5mm.

Downstop affect the Droop, these 2 has no direct relationship with ride hight.

The higher the downstop value, the lower the droop value. Because the lowest position of the A-ARM is limited byt he downstop.

The best is to refer to the Xray Setup Guide.

歡迎光臨 RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區 (https://jk.rc-evo.com/xbbs/)