師兄用咩電?叉滿未?
試下reset esc
VXL-3s Setup Programming (Calibrating your ESC and transmitter)
Read through all of the programming steps before you begin. If you get lost
during programming or receive unexpected results, simply unplug the battery,
wait a few seconds, plug the battery back in, and start over.
1. Connect a fully charged battery pack to the VXL-3s.
2. Turn on the transmitter (with the throttle at neutral).
3. Press and hold the EZ-Set button (A). The LED will first turn green and then red. Release the EZ-Set button.
4. When the LED blinks RED ONCE, pull the throttle trigger to the full throttle position and hold it there (B).
5. When the LED blinks RED TWICE, push the throttle trigger to the full reverse and hold it there (C).
6. When the LED blinks GREEN ONCE, programming is complete. The LED will then shine green or red (depending on low-voltage detection setting) indicating the VXL-3s is on and at neutral (D).
1. 叉滿電
2. 開控
3. 長按電變開關, led 會由綠轉紅, 放開開關
4. led 閃紅一下, 比盡油
5. led 閃紅2下, 比盡break
6. led 閃綠1下, done , 如果li-po cutoff 開左會長著綠, off 左會長著紅, 玩nimh 要off
