RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區

標題: 我想問e個型號既車裝唔裝到D90個殼架~? [打印本頁]

作者: raymond_lai1116 時間: 2010-5-30 00:48
標題: 我想問e個型號既車裝唔裝到D90個殼架~?
本帖最後由 raymond_lai1116 於 2010-5-30 00:59 編輯

登錄/註冊後可看大圖

唔知得唔得呢~~??
仲有幾多錢到a??e架野~?

作者: chowhungjai 時間: 2010-5-30 01:16
cc01 would fit on D90 shell with some minor modification

作者: snowsenki 時間: 2010-5-30 02:05
回復 1# raymond_lai1116
我想買多個Pajero殻
祢想買CC01底
有無興趣夾份？

作者: raymond_lai1116 時間: 2010-5-31 01:24
回復 2# chowhungjai

O....THANK YOU~

ja係所有既cc01底盤都可以裝落D90既殼到...但只係要改直尾擔盲可以~?

RE:snowsenki
師兄~唔好意思a...因為我宜家仲係考慮緊....買唔買~~但係見到d師兄上山玩...好似好正咁...攪到我中哂毒~~

作者: chowhungjai 時間: 2010-5-31 01:38
回復 4# raymond_lai1116

Not really, if it is possible, get the VW tourage kit, coz it include the long propeller shaft. If you take the pajero, it include the short propeller shaft that it won't fit on D90. Or you buy the long propeller shaft separtely. Moreover, you may need to modify the rear suspension a little bit to fit the D90 shell.

作者: raymond_lai1116 時間: 2010-5-31 01:46
回復 5# chowhungjai

師兄...我唔係好明a...

但係我會慢慢理解下~~你ja係話如果買pajero e個型號~會用唔到D90個殼~因為個條直濕會短..唔岩裝???咁如果買邊隻款會岩d~?

唔該哂師兄~~

作者: raymond_lai1116 時間: 2010-5-31 01:54
回復 7# C仔

哦~~明白~~唔該師兄~

作者: chowhungjai 時間: 2010-5-31 13:10
what I recommend is get the tamiay VW tourage kit(coz it got long propeller shaft), after you got that kit, you still have to extend the wheel base, coz it is not perfectly fit the D90 shell. The defender shown in the photos has long propeller shaft, but the wheel base have not been extended, you can see the rear wheel is very close to the wheel well!!

作者: 拉登.狂徒 時間: 2010-5-31 13:56
GOOD

作者: RC881 時間: 2010-5-31 14:10

what I recommend is get the tamiay VW tourage kit(coz it got long propeller shaft), after you got th ...
chowhungjai 發表於 2010-5-31 01:10 PM

登錄/註冊後可看大圖

C兄裝在車上的四條呔鈴, 係唔係F350果set ?

作者: chowhungjai 時間: 2010-5-31 16:36
回復 11# RC881

Yes, they are F350 tires

作者: raymond_lai1116 時間: 2010-6-1 00:35

what I recommend is get the tamiay VW tourage kit(coz it got long propeller shaft), after you got th ...
chowhungjai 發表於 31-5-2010 01:10 PM

登錄/註冊後可看大圖

師兄a~咁你e個係咪ja係冇延長到條直濕a??只係用個shell黎就返佢~?所以頭呔同尾呔冇咁對齊~

作者: chowhungjai 時間: 2010-6-1 00:52
回復 13# raymond_lai1116

My defender is using the long 直濕(from the Tamiya VW Tourage), but as you can see in the photos, the rear wheel is very close to the wheel well, need to extended the whole rear suspension assembly a little bit!!

作者: raymond_lai1116 時間: 2010-6-1 01:19
回復 14# chowhungjai

哦~~唔該哂chowhungjai 師兄~~
THANK YOU VERY MUCH~~

作者: peter7 時間: 2010-6-1 01:59
This chassis doesn't require any modification:
http://rc4wdstore.com/2/product_ ... amp;products_id=992

pm me if you want to buy one.

作者: raymond_lai1116 時間: 2010-6-1 22:32
回復 16# peter7

師兄~~好正a~@@但係...$3xxx

作者: peter7 時間: 2010-6-1 22:47
Brand new complete with D90 body: HK$3500

作者: wynn 時間: 2010-6-2 00:47
如型丫......

歡迎光臨 RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區 (https://jk.rc-evo.com/xbbs/)