tb rvo 5.JPG (198.82 KB, 下載次數: 2)
Manual
2010-6-26 12:46 上傳
作者: hardmankam 時間: 2010-6-26 12:59
Just apply instant glue on the edges. This will prevent the carbon layers from splitting. I use the CA glue with a brush head. Just apply a little at a time. very thin layers.
作者: f-16 時間: 2010-6-26 22:17
本帖最後由 f-16 於 2010-6-26 22:18 編輯
點呀?! 你之前的 TB 5 臂改 TB 5 MS 隻416臂可吾可行呀?
作者: lui222k 時間: 2010-6-26 23:41
車到手啦!! 恭喜 恭喜
作者: resound 時間: 2010-6-26 23:54
多謝!
TB 5 MS 隻416臂 要等Parts, 七月中先有貨.
Thank you hardmankam, good to know about the glue situation
| 歡迎光臨 RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區 (https://jk.rc-evo.com/xbbs/) | Powered by Discuz! X3.2 |