RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區
標題: Shell for TA05VDF [打印本頁]
作者: gimsink 時間: 2010-7-27 16:05
標題: Shell for TA05VDF
chings pls help :
1/. 190 or 200mm shell is suitable for TA05VDF ?
2/. 24 or 26mm tire width is suitable ??
3/. any offset is required ???
I check every page of the manual but it has nothing mention about this....
作者: 搖控新手 時間: 2010-7-27 16:46
回復 1# gimsink
請問是不是已完成？
用甚麼摩打和電變和servo？
作者: hhxhkuroro 時間: 2010-7-27 18:47
190mm
26mm maybe better
no off set on 190mm
i use sp v3 13.5t and sp pro stock esc,
align ds610 servo
作者: z96282424 時間: 2010-7-27 18:56
chings pls help :
1/. 190 or 200mm shell is suitable for TA05VDF ?
2/. 24 or 26mm tire width is su ...
gimsink 發表於 2010-7-27 16:05
1. 如果你用雙星SUPER DRIFT TIRE就用190MM SHELL IS OK, 200MM SHELL 配super drift tire要配返套+2offset 鈴先靚, 同埋唔係隻隻雙星殼都係 0 offset, 有D就頭 0 後 +2, 有D就頭尾都+2等等...
2. 24mm tire就super drift啦, 26mm就好多隻牌子都得, 不過如果初學都係super drift開始比較好/平...
3. 26MM最好offset +2以上啦, 遲D改大個轉向可能會頂油壓, 呢點未試真, 架車太新...
作者: gimsink 時間: 2010-7-27 19:17
回復 gimsink
請問是不是已完成？
用甚麼摩打和電變和servo？
搖控新手 發表於 2010-7-27 16:46
Drift car no need too fast, I use Hobbywing 35A/8.5T, servo not buy yet, no time...
作者: gimsink 時間: 2010-7-27 19:24
190mm
26mm maybe better
no off set on 190mm
i use sp v3 13.5t and sp pro stock esc,
align ds610 ...
hhxhkuroro 發表於 2010-7-27 18:47
ching, I find a very serious issue, the rear belt very easy to fall off the belt tensioner's bearing if motor run full speed, (see photo below), do you have the same problem ?
