RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區

標題: Charging Lipo, please help [打印本頁]

作者: peter7 時間: 2010-9-22 02:14
標題: Charging Lipo, please help
Just switch to Lipo and bought myself a balance charger and a 3500mAh pack. Should I discharge it first before charging? What is charge by 1C mean? Is it mean I should set charging rate of 3.5A? Please help. Thanks!

作者: Noir.KAZE 時間: 2010-9-22 08:29
no need to discharge
3.5A is OK

作者: peter7 時間: 2010-9-22 12:39
Thanks c hing

作者: hardmankam 時間: 2010-9-22 13:58
another tip:
if you are not using the lipo for a long time (>1 month), you can use 'storage' mode to charge up your lipo. this way, you lipo will not swell up.

if your charger does not have storage mode, just charge it until each cell is about 3.8-3.9v, then stop.

作者: coolgod903 時間: 2010-9-22 20:52
It is don't use it below 3.3 or 3.6 r?????

作者: peter7 時間: 2010-9-24 01:15

another tip:
if you are not using the lipo for a long time (>1 month), you can use 'storage' mode t ...
hardmankam 發表於 2010-9-22 13:58

登錄/註冊後可看大圖

My charger has the storage mode. But can you tell me what is the benefit of using this mode? Is it because keep the LiPo pack full charge without using it will cause damage? Thanks!

作者: Noir.KAZE 時間: 2010-9-24 01:26

My charger has the storage mode. But can you tell me what is the benefit of using this mode? Is ...
peter7 發表於 2010-9-24 01:15

登錄/註冊後可看大圖

yes.......

作者: peter7 時間: 2010-9-24 01:31
Thanks again.

作者: tsk28 時間: 2010-9-24 10:03
想問問個STORAGE MODE是否要SET什麼的, 比如 SET 個 VOLT 數, 差到幾多V會停之類.

作者: hardmankam 時間: 2010-9-24 11:06
回復 9# tsk28

Storage mode 會自動 cut, 冇必要SET什麼.

作者: hardmankam 時間: 2010-9-24 11:07
回復 6# peter7

Yes, if you full charge then let lipo sit for too ling without using, it will cause swollen and damage the battery (aka 肥仔電). So there is storage mode to put the right amount of capacity into the lipo.

作者: tsk28 時間: 2010-9-24 12:14
明白, 謝謝指點

作者: coolgod903 時間: 2010-9-24 12:15
can use until 3.3 or 3.6 each cell ar?????

作者: hardmankam 時間: 2010-9-24 12:53
回復 13# coolgod903

if slow motor, set cutoff at 3.2v/cell
if fast motor, set cutoff at 3.4v/cell

歡迎光臨 RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區 (https://jk.rc-evo.com/xbbs/)