RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區
標題: T3 battery tray from Atomic [打印本頁]
作者: GigaRacer 時間: 2010-10-7 11:54
標題: T3 battery tray from Atomic
Any T2 / T3 c hing uses this? Thanks!
-
作者: 威威 時間: 2010-10-7 11:57
師兄呢舊野都幾肉吓喎～～不過用呢舊野會頂二樓板或者要舊電坐出ｄ先可以用到！
作者: GigaRacer 時間: 2010-10-7 11:59
肉 ah? It said, by adjusting the in&out position to balance the weight, then no need to add weight.
作者: rabbitmomo 時間: 2010-10-7 12:04
呢舊野麻麻地, 正如威威CHING講,用o係T2/T3一定要坐出, 我覺得穿膠紙位要換膠紙時好唔方便
作者: GigaRacer 時間: 2010-10-7 12:08
c hing, I am new hand, use velcro instead of tape 
thinking to try this out.
作者: rabbitmomo 時間: 2010-10-7 12:13
c hing, I am new hand, use velcro instead of tape
thinking to try this out.
GigaRacer 發表於 2010-10-7 12:08
That way the battery cannot be held firmly by velcro
作者: 威威 時間: 2010-10-7 12:13
ｘｒａｙ有舊電池頂夾，係用擰既，唔洗用膠兜就唔洗高左要坐出舊電啦！
作者: pskyng 時間: 2010-10-7 13:01
我用緊. 覺得好方便及對lipo保護性好好. 因為係用兩條摩術貼, 兩貼ok. 另外那tray的高度係唔會頂二樓板. 若用一般厚lipo 唔使坐出. 當用較厚lipo, 就可以好方便咁坐出免頂二樓板,尤其我0的lipo電唔同厚度,所以好適合. 而坐出for 車架平衡都有幫助.所以我會keep住較出小小. 不過個tray本身有厚度. 舊電CG會高左
至於肉..ha. 個車殼lup住唔係好介意. 個人覺得最緊要方便.
作者: GigaRacer 時間: 2010-10-7 13:58
c hing, good info. could you share some pictures of your car?
作者: rcpop 時間: 2010-10-7 14:03
How much ... ?
作者: pskyng 時間: 2010-10-7 15:47
c hing, good info. could you share some pictures of your car?
GigaRacer 發表於 2010-10-7 13:58
得張好細.
...haha. ,要型就更係貼膠紙la. 
