標題: team power motor axis [打印本頁] 作者: FatboyHK 時間: 2010-10-12 16:20 標題: team power motor axis I just broke my motor axis..... it is a tp 8.5t
I have another tp 4.5t motor with a dead sensor. I am wondering if I can take that axis and use it in the 8.5t motor? Are they the same?作者: hardmankam 時間: 2010-10-12 16:22
the rotors are the same.作者: FatboyHK 時間: 2010-10-12 16:25
Very good ching, save some $
Is it easy to install? Any special caution?作者: hardmankam 時間: 2010-10-12 17:02
very easy, just take out the old/broken rotor. check how many spacers there are (if any) on both ends of the old rotor. Add the same amount of spacers to the new rotor (or make sure the spacing are the same). then just carefully insert the new one into the motor can.
when you finished, make sure there is some small movements on the rotor (or no binding) or else the motor will get too hot.作者: FatboyHK 時間: 2010-10-12 18:56
done, it is simpler than i thought, thanks for your advice.