RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區

標題: 3、7v升壓問題 [打印本頁]

作者: 空降兵 時間: 2010-10-14 22:54
標題: 3、7v升壓問題
Novak Smart Boost 1-cell Li-Po Step-up Module

Novak Smart Boost 1-cell Li-Po Step-up Module一
請問有左以上用品就可以用3。7v电升压比接收电娈及司伏

作者: trainer 時間: 2010-10-14 22:58
Yes, u are right.

作者: jf813 時間: 2010-10-14 22:58
yap, boost from 3.7v to 6v.

作者: 空降兵 時間: 2010-10-14 23:33
多謝師兄

作者: GigaRacer 時間: 2010-10-15 02:37
本帖最後由 GigaRacer 於 2010-10-14 10:38 編輯

or use this. micro 7.4v Lipo receiver battery.

作者: 3rock3rock 時間: 2010-10-15 06:30
7.4V?
Is it too high in voltage
Life 6.6v is better wor

作者: jf813 時間: 2010-10-15 09:38
If you use newer KO, Spektrum receiver you can use 7.4V 2S lipo directly. (sorry not sure abut futaba and sanwa). And don't forget to check the servo too as most servo donot accept 7.4v (only newer highend servo's do). If your servo or receiver donot accept 7.4V you need to add a BEC to lower the voltage to 6V....

作者: hardmankam 時間: 2010-10-15 11:24

If you use newer KO, Spektrum receiver you can use 7.4V 2S lipo directly. (sorry not sure abut futa ...
jf813 發表於 2010-10-15 09:38

登錄/註冊後可看大圖

Agree, if use 7.4v Lipo, better to use BEC to lower to 6V.
I have used 6.6v Life Rx w/o BEC and it works perfectly.
(with KO receiver and Futaba servo)

歡迎光臨 RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區 (https://jk.rc-evo.com/xbbs/)