RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區

標題: Pro Ten vs 1/12 in JV [打印本頁]

作者: Edwin 時間: 2011-3-4 12:28
標題: Pro Ten vs 1/12 in JV
It maybe be a silly question...................Which one should have better lap time in JV if motor, ESC and battery are the same?

作者: raymomo 時間: 2011-3-4 14:13
12仔快d!因為輕d

作者: mikuro 時間: 2011-3-4 14:17

12仔快d!因為輕d
raymomo 發表於 2011-3-4 14:13

登錄/註冊後可看大圖

12仔快d x 2
12仔一般比 10仔輕 (ie. 745g vs 997g)

作者: Edwin 時間: 2011-3-4 15:22
ProTen has wider tyres, maybe it has higher corner speed?

作者: mikuro 時間: 2011-3-4 15:35
本帖最後由 mikuro 於 2011-3-4 16:22 編輯

ProTen has wider tyres, maybe it has higher corner speed?
Edwin 發表於 2011-3-4 15:22

登錄/註冊後可看大圖

But, the frictional loss on Pro Ten would be higher when compare to 1/12 pan car in some case .

I have tried testing 1S + 4.0T on my 1/12 pan car and Pro Ten (235mm). Although the rollout of Pro Ten is greater than my XII link car (22/96 on both cars), the overall speed / acceleration feels like that my XII link is a bit better. Also, the overall weight of a 1/12 pan car is lighter than Pro Ten.

However, since I have conducted 1 test only, it may not be 100% correct unless more test data to justify ^^

What if both cars running at 7.4V? If then, will 1/12 pan car slip during cornering? You may replace a hard side springs to improve the response / cornering then.

作者: blueray 時間: 2011-3-4 17:57
hope to have some event to compare with same elec configure.
if any c-hing can take a video would be perfect.

歡迎光臨 RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區 (https://jk.rc-evo.com/xbbs/)