IMG061.jpg (457.91 KB, 下載次數: 18)
2011-4-28 22:57 上傳
作者: pma 時間: 2011-5-9 15:56
You may check servo database (www.servodatabase.com) for details dimension.
作者: pma 時間: 2011-5-9 16:04
回復 gimsink 的帖子
I also face same problem before.
I bought a hop-up mount but it can't fit exiting servo.
Two way I could choice, 1. forget the new mount 2. buy a new servo that fit the new mount.
However, another issues was found - connector size and torque.
Normally, I can select 9g servo but it seems that connector size is difference and torque
is not enough. Finally, I give it up.
作者: gimsink 時間: 2011-5-9 23:13
最后用十蚊買左把三再角銼, 將 servo mount 兩邊銼到 fit 位, 免強裝倒. 然后发覺個 servo saver 吸唔入, 死死氣去外國網站訂套原廠 servo saver, 計埋运費成百蚊, 死味 ! 如果再有野坏就 Dump 七左架 SC18 仔 !
作者: pma 時間: 2011-5-10 00:05
I already gave up my RC18T and return to 1:10 off road.
作者: lcpvcce 時間: 2011-5-10 12:41
本帖最後由 lcpvcce 於 2011-5-13 10:40 編輯
I used this one SANWA ......................
作者: gimsink 時間: 2011-5-10 22:52
師兄你個servo mount 同埋底板係原裝定係補品 ? 边度買 ?
作者: lcpvcce 時間: 2011-5-10 22:59
Ching I m new hand also ................Chassis and motor mounting were made by associated team factory and regarding servo mount from ebay.
作者: pma 時間: 2011-5-10 23:57
回復 lcpvcce 的帖子
Where can buy the wheel adaptor? Thanks.
作者: lcpvcce 時間: 2011-5-11 20:13
回復 pma 的帖子
KWS.........
作者: pma 時間: 2011-5-11 22:16
Red Star??
| 歡迎光臨 RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區 (https://jk.rc-evo.com/xbbs/) | Powered by Discuz! X3.2 |