絲攻係邊到買？大約幾錢支？ thx作者: d.s 時間: 2011-7-10 17:28
去小強度睇下啦 http://kkchung.pixnet.net/blog/post/27619685作者: 戰友 時間: 2011-7-10 17:38
絲攻在一些大一点的五金鋪就有,攞埋粒鏍絲去買,好点的$3x左右.作者: 870110a 時間: 2011-7-10 22:07
點解用英制64份5嘅六角匙???? 作者: greenracing83 時間: 2011-7-11 17:35
sakura lower level than T3, 416x etc..作者: cherwowo 時間: 2011-7-11 17:38
支六角批就快爛 粒縲絲都未上好 ===> Use the screw to make the hole bigger before actually screwing it on to the car (though not too big, otherwise will be too loose). Get a hex screw driver with a bigger handle from Ap Liu Street.
牙差漏油 ===> Take it apart and re-assemble. Make sure the rubber seal is fitted properly. Make sure the 4 screws are tight. 作者: bearbear1991 時間: 2011-7-11 20:29
thx 咁多位師兄~~我今日買左枝好d既6角批 & 絲攻....好好用
