Front:
3V white super bright LED <---> 220 ohm resistor (in series)
(Make 2, one for each side)
Back:
2V red super bright LED <---> 270 ohm resistor (in series)
(Make 2, one for each side)
Now you should have 4 LEDs with resistors. Connect them in parallel to a connector which plugs into the VCC port of the receiver.
Should cost around $25 for Ap Liu St. For cables, it's up to you (I use cheap cheap wires inside a Cat 5 cable =) ) 作者: ahdofung 時間: 2011-7-17 13:14
好清楚, 多謝哂!作者: cman-007 時間: 2011-7-19 20:51
可否有圖...就仲清楚啦!作者: chui 時間: 2011-7-19 21:18
