RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區

標題: T3 2011 齒輪比 ask [打印本頁]

作者: sex8088    時間: 2011-8-24 15:25
標題: T3 2011 齒輪比 ask
speed passion 2.0 pro esc, speed passion 4T motor old model, 64 PITCH, USE 114T/20T MOTOR TEMP 89 DEGREE, VERY HOT,  AND USE 114T/24T MOTOR TEMP 83 DEGREE, ALSO STILL VERY HOT,

ANY CHING CAN RECOMMEND BEST 齒輪比 ?
作者: defcone    時間: 2011-8-24 15:38
You running a fan? Maybe go lower fdr, you're at 9+fdr and the motor might be over revving. Try 8.5 or 8, run the car for 2 minutes and temp the motor. What firmware are you running in the esc?
作者: hardmankam    時間: 2011-8-24 16:09
Yeah, what firmware are you running on your SP v2.0?  Mod or Stock firmware?
For Mod firmware, you can also tune down the punch level (mode #4) and also the ESC timing (mode #9)

Also check on the motor timing ring.  SP motors has A, B and C settings.  By turning clockwise (A setting), you will decrease timing, thus a cooler motor.  And by turning counter-clockwise (C setting), you will increase timing and the motor can be very hot.

A typical FDR for 4T motor is between 9 - 10.

作者: sex8088    時間: 2011-8-25 02:26
回復 defcone 的帖子

v1.1_090323  thx
作者: sex8088    時間: 2011-8-25 02:45
回復 hardmankam 的帖子

v1.1_090323  , AMTS TIMING LAST CHOICE IS 8. NO MORE CHOICE CHOOSE 9, CHOOSE 8 STILL OK? thx
作者: defcone    時間: 2011-8-25 08:58
sex8088 發表於 2011-8-25 02:45
回復 hardmankam 的帖子

v1.1_090323  , AMTS TIMING LAST CHOICE IS 8. NO MORE CHOICE CHOOSE 9, CHOOSE ...

Yes you can go lower as this reduces timing, and makes the motor cooler. What motor timing are you running?
作者: hardmankam    時間: 2011-8-25 09:52
you may download the manual here:
http://www.speedpassion.net/uplo ... al_Sept14th2010.pdf

Setting4 is called 'start mode' (or punch level) the higher number, the bigger punch. For mod motor, maybe setting 3 or 4.

Setting9 is called 'Timing', higher number, higher power and more heat.  For mod motor, try a lower number, maybe 2 or 3.  (ie 8 is adding 26.25degree, which is the hottest)






歡迎光臨 RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區 (https://jk.rc-evo.com/xbbs/) Powered by Discuz! X3.2