正常副機上到油係因為入面既活塞運動產生負壓而將油吸上嚟,如果你要倒轉部車等啲油高過engine先著到,咁好有可能係入面既油路阻塞了,所以當啲油灌入去就著到,放平就即刻死火,你試下鬆咗大針出嚟,由嗰度同油喉入油位滴啲油入去,睇下滴油會唔會由入風位出番嚟,如果唔會咁即係嗰度塞咗啦作者: fung2010 時間: 2012-1-19 19:49
副engine 玩過?仲有無壓縮?作者: alanalan_27 時間: 2012-1-20 00:21
會唔會油針過大呀 =冇左真空原理作者: kinman18 時間: 2012-2-7 00:46
換返透明油喉會唔會睇得清楚d呀? 著咗機狂油泵上油會唔會死先?作者: bear_cat_x 時間: 2012-2-10 17:00
hi, i am a new member and would like to help:-
1. without the glow plug battery, plug the exhaust hole and pull the engine to see if fuel goes into the engine. if ok then start your engine as usual. if not ok, see step 2 below.
2. without the glow plug battery, plug the exhaust hole as well as the air intake hole and pull the engine to see if fuel goes into the engine. if ok then start your engine as usual. if not ok, there should be some serious sealing problem between connections in the engine. observe if there is any fuel leakage when you pull the engine and check the seal at the leakage location.作者: too7559 時間: 2012-2-21 07:48
有個直接方法,換過架!作者: cpkd 時間: 2012-2-21 11:18
拎出黎比啲師兄睇下啦! 唔着可以好多原因...作者: serpentkkk 時間: 2012-2-21 22:54
望你部愛驅我就諗起十一年前首次玩的第一部油車..........你仲有呢部油車玩都幾勁喎師兄,呢部車的特點就係唔可以換部勁啲的引擎只可以用原裝問你死未。作者: serpentkkk 時間: 2012-2-21 22:57 回復 too7559 的帖子