標題: FF01 Upgrade with 416 Front Suspension [打印本頁] 作者: oliverchu 時間: 2012-3-17 15:27 標題: FF01 Upgrade with 416 Front Suspension With new Front Suspension, you no need to worry about the vintage Spare Parts
作者: felita 時間: 2012-3-17 17:03
Ching, how to mount the battary? In addition, is front wheel distance great than rear wheel?作者: hihizaza 時間: 2012-3-17 18:28
唔使咁喎，我賣包原裝臂比你丫作者: tiger1 時間: 2012-3-17 19:44
好法子作者: oliverchu 時間: 2012-3-17 23:41 回復 felita 的帖子
use the brecket which from TA02 FRP upgrade kit, then u can use both stick batt or lipo作者: oliverchu 時間: 2012-3-17 23:46 回復 hihizaza 的帖子
haha, l don't like the short A arm, most important is that the new CVD's quality is much better than the old one作者: tiger1 時間: 2012-3-17 23:51
no doubt the new CVD has better tolerance than the older one 作者: minimini 時間: 2012-3-18 00:37
DIY graphite chassis ??作者: chacha 時間: 2012-3-18 04:00
我已為頭尾都改埋添作者: tiger1 時間: 2012-3-18 07:36
TAMIYA TA02 original Carbon plate kit.
Next Step is DIY a Carbon Chassis & upper deck to use 416/417 Rear Suspension
......
Then, The car just look like FF03,haha...作者: pkmarc 時間: 2012-4-3 13:16
HOw can you do it?
Can you give some hints to me?
Thanks a lot 作者: hihizaza 時間: 2012-4-3 14:52
個尾改到咁神化
比相睇下先得架作者: oliverchu 時間: 2012-4-3 16:40 回復 pkmarc 的帖子
If you have both 416 Frt Suspension arm and FF01 Chassis, just measure the width of that conection, only widder 1mm, so ,just remove some material of 416 arm, then you can use it!
Use the original PIN is fine.
About the upper link, also use the original hole on the shock tower
BTW: Must use 44mm dog bone. 46mm is too long.作者: pkmarc 時間: 2012-4-4 11:35
thanks a lot作者: TOTOTOTO 時間: 2013-9-12 23:16
Any Spare part of bumper
Any other part to replace the damaged bumper
