1001b.jpg (81.59 KB, 下載次數: 6)
2012-4-1 11:32 上傳
作者: hihizaza 時間: 2012-4-1 13:01
最好駁到同樣有藍色線的舊式變速，如Novak的410M1c,410Mxc,如不能的話駁到servo插的正極也可
作者: hihizaza 時間: 2012-4-1 13:03
你圖中駁法有點奇怪，好像駁到訊號線
作者: garywong5368 時間: 2012-4-1 23:02
我cut左藍色線直接拆殼駁入+極便可
作者: fbs 時間: 2012-4-2 11:10
The blue wire is for power of the motor inside the servo. It can connect to voltage higher than 6V ( from the receiver). It can be 7.2V, 8.4V or 9.6V to increase the speed of the servo. This wire is use to separate the power of the servo motor to the control signal. You should not connect to the blue wire of the original servo cord as it will cause short circuit. You can only connect to the red wire of the sevo cord but it will slow down the speed of the servo as the input voltage is 6V only. Masami use 2 additional battery ( small size ) for the steering servo ( the first KO FET servo ) to speed up the servo when he win his first world title.
作者: Client 時間: 2012-4-2 15:10
Thank you all Ching valuable RC experience !
Thank you so much.
| 歡迎光臨 RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區 (https://jk.rc-evo.com/xbbs/) | Powered by Discuz! X3.2 |