RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區

標題: 用B6差NiMH電問題~ [打印本頁]

---

作者: dsds    時間: 2012-6-15 00:42
標題: 用B6差NiMH電問題~
小弟有幾粒白色SANYO白色1900mAH既電芯,
想問下各位師兄如果用B6差電機差佢地應該用咩seting?
因為我試過用1A差,大約半小時佢地就叉完而且會超熱!
所以想向各位請教一下,謝謝!

---

作者: yipd    時間: 2012-6-15 11:21
正常因為快差一定會發熱

---

作者: ray2011    時間: 2012-6-15 12:52
回復 dsds 的帖子

加風扇吹

---

作者: dsds    時間: 2012-6-15 12:57
但係差完又好快用完，有冇得正常差？

---

作者: TigerI2010    時間: 2012-6-15 13:51
用探温線一起差，過熱時自動降低電流差。
不過我都祇用0.4A電流差。

---

作者: gta    時間: 2012-6-15 14:00


回復 TigerI2010 的帖子

所有電太大a數差排電會短命

---

作者: gta    時間: 2012-6-15 14:06
回復 TigerI2010 的帖子

經常高a數差死得仲快

---

作者: bear_cat_x    時間: 2012-7-6 01:34
Ching, if you set charging current of 1a for a 1900 battery, charging period shall be at least 1.9 hours. Complete charging for less than this showing there must be some problems in your battery such as it has not been properly discharged before being charged. May I ask you what is the designated voltage of your battery and the charging voltage shown in the b6 when charging is nearly completed.

---

歡迎光臨 RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區 (https://jk.rc-evo.com/xbbs/)

Powered by Discuz! X3.2