RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區

標題: Sp 2.0pro esc原裝program card 係咪set唔倒turbo架？ [打印本頁]

作者: vin00002002 時間: 2012-6-15 02:46
標題: Sp 2.0pro esc原裝program card 係咪set唔倒turbo架？
在esc 個set制度可唔可以做到？ tkx! Ching

作者: vin00002002 時間: 2012-6-15 02:49
If I don't buy USB program card, then cannot updated? Mine is v1.6, is it too old?

作者: tb03 時間: 2012-6-15 03:31
回復 vin00002002 的帖子

用HW program card upgrade是共用的

作者: Chrischu33 時間: 2012-6-15 20:08
u need to upgrade firmware first

作者: vin00002002 時間: 2012-6-16 00:56
That means original program card can't set turbo even the (set button on switch)?

作者: vin00002002 時間: 2012-6-16 00:57
Original can't use less that 10.5t motor? Mine is 5.5 sensorless.

作者: kkchung 時間: 2012-6-16 02:47

vin00002002 發表於 2012-6-16 00:56

登錄/註冊後可看大圖

That means original program card can't set turbo even the (set button on switch)?

當更新了 428Stock 或 428MOD 後便不能用開關側面的小按鍵進入program model 設定功能。而原裝的七劃管 program card 也不能用，雖要改用 LCD Professional Program Card。

作者: vin00002002 時間: 2012-6-16 22:55
Tkx for ur info. If I don't update, can I use set button on switch to set turbo, n can the original esc use sensorless 5.5t motor?

作者: kkchung 時間: 2012-6-20 19:11

vin00002002 發表於 2012-6-16 22:55

登錄/註冊後可看大圖

Tkx for ur info. If I don't update, can I use set button on switch to set turbo, n can the original ...

之前買到的 GT2.0 Pro 內裡 Firmware 是沒有 Turbo 功能。要更新 Firmware至323STOCK 開始才有。更新了便不能用開關側面的小按鍵進入program model 設定功能。而原裝的七劃管 program card 也不能用，雖要改用 LCD Professional Program Card。而原裝 GT2.0 Pro 可用低至 3.5T 也沒問題。

作者: vin00002002 時間: 2012-6-21 03:16

kkchung 發表於 2012-6-20 19:11

登錄/註冊後可看大圖

之前買到的 GT2.0 Pro 內裡 Firmware 是沒有 Turbo 功能。要更新 Firmware至323STOCK 開始才有。更新了便 ...

Many tkx, ching

歡迎光臨 RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區 (https://jk.rc-evo.com/xbbs/)