標題: 請問珠差和牙差, 有什麼分别? [打印本頁] 作者: peterdog 時間: 2012-7-6 11:10 標題: 請問珠差和牙差, 有什麼分别? 請問珠差和牙差, 有什麼分别?作者: felita 時間: 2012-7-6 11:26
Please refer to the following link
http://www.rc-evo.com/m_newhand/hand029.html作者: peterdog 時間: 2012-7-6 11:51
Thanks作者: tiger1 時間: 2012-7-6 12:24
ball diff in general believe to be smoother and more adjustable than gear diff.
In reality, good ball diff and good gear diff are about the same except gear diff cannot slip at all but ball diff may slip under extreme high load.作者: Chrischu33 時間: 2012-7-6 13:05
can somebody explain how to build ball diff smoothly? thx作者: kinderting 時間: 2012-7-6 13:56 http://www.youtube.com/watch?v=M_u9yKV2TPM作者: simon540 時間: 2012-7-6 16:28
其實珠差速應該緊D?鬆D?還是要剛剛好?作者: Chrischu33 時間: 2012-7-6 17:42 回復 kinderting 的帖子
can somebody explain how to build ball diff smoothly? thx
It starts off with a well designed ball diff. Some diff that are not well made or with structural issues can never been built smoothly. Assuming it is a well designed diff, use Associated clear ball diff grease for the main balls and black grease for the pressure washer (smaller balls), they are by far the best I know of. 作者: tiger1 時間: 2012-7-8 00:18
Ball diff WILL get damage if it is too loose. Years ago, ball diff are built to allow a little slip but nowadays most buggies have slipper clutch, so the need of slip in a ball diff is unnecessary. IMHO, ball diff should be 'just right', that means smooth to hand touch but no slippage on gas throttle.作者: peterdog 時間: 2012-7-8 22:26
Thanks all.
