RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區

標題: 3Racing OP part for DF03 [打印本頁]

作者: gary1986 時間: 2006-11-5 08:30
標題: 3Racing OP part for DF03
Tamiya Dark Impact DF03
Conversion Kit is made of the following components bbs.rcfans.comY#j5e$a!Xj
Graphite Chassis Set Side Chassis Right Side Chassis Left Rear Bulkhead Bae Plate Chassis Battery Cover Front Bulkhead Bae Plate

登錄/註冊後可看大圖

Aluminum Front and Rear Damper Set

登錄/註冊後可看大圖

Here comes our special design Aluminum Front and Rear Damper Set(DF03-01/LB).3Racing adopts Aluminum as the material which allows the oil dampers to run the best shockproof function. In order to run the function well, we insert the piston inside the damper. The consistency of the oil just depends on the car weight. The heavier the car is, the thicker the oil would be. For the first time, we even uniquely change the shock tower from Plastic to Aluminum so as to increase its shockproof power.

Aluminum Propeller Joint (DF03-05/LB) & Bevel Shaft Set (DF03-17/LB)	登錄/註冊後可看大圖
Our Aluminum Propeller Joint (DF03-05/LB) needs to be used with our Bevel Shaft Set (DF03-17/LB). On the Bevel Shaft Set, there is the Plastic Joint Adaptor, it would make the joint more durable. Even if there is damage, the Plastic Joint Adaptor would bear the damage for the Bevel Shaft.

Aluminum Front and Rear Shock Tower	登錄/註冊後可看大圖
The last but not least, 3Racing would like to introduce our Front and Rear Shock Tower to you. There would be 2 Graphite pieces and an Aluminum piece to form such a shock tower. It would allow the tower to run the best shockproof function.

作者: Eddie168 時間: 2006-11-5 09:16
用唔用到橫電?

作者: gary1986 時間: 2006-11-5 13:57
標題: ..

原帖由 Eddie168 於 2006-11-5 09:16 發表
用唔用到橫電?

5得.

...KM個塊可以..用分體電

登錄/註冊後可看大圖

作者: Eddie168 時間: 2006-11-5 19:44
佢個油壓架好正,全套幾$到?

作者: petscan 時間: 2006-11-6 16:08
Good. Particularly the shock tower. Must be better than the plastic original one. We are so lucky to live in Hong kong. There are many cheap hop up parts available.

作者: gary1986 時間: 2006-11-6 20:14

原帖由 petscan 於 2006-11-6 16:08 發表
Good. Particularly the shock tower. Must be better than the plastic original one. We are so lucky to live in Hong kong. There are many cheap hop up parts available.

agree....

i"M go to kwss"RCshop only 30min and use RMB$90(get to there and back).get fun

作者: Eddie168 時間: 2006-11-8 01:15

原帖由 petscan 於 2006-11-6 16:08 發表
Good. Particularly the shock tower. Must be better than the plastic original one. We are so lucky to live in Hong kong. There are many cheap hop up parts available.

但我唔係呢

作者: minimini 時間: 2006-11-9 00:55

原帖由 petscan 於 2006-11-6 16:08 發表
Good. Particularly the shock tower. Must be better than the plastic original one. We are so lucky to live in Hong kong. There are many cheap hop up parts available.

我去 KWS 睇過份 3-racing 頭油壓架......

好慶幸我之前買左 Five-Stars 嘅出品......真係物有所值........冇得比 (質素 & 價錢都係).......

[ 本帖最後由 minimini 於 2006-11-9 01:03 編輯 ]

作者: gary 時間: 2006-11-9 01:50

原帖由 minimini 於 2006-11-9 00:55 發表

我去 KWS 睇過份 3-racing 頭油壓架......

好慶幸我之前買左 Five-Stars 嘅出品......真係物有所值........冇得比 (質素 & 價錢都係).......

咁似Square個份既,又係OEM??

作者: petscan 時間: 2006-11-10 23:18

原帖由 minimini 於 2006-11-9 00:55 發表

我去 KWS 睇過份 3-racing 頭油壓架......

好慶幸我之前買左 Five-Stars 嘅出品......真係物有所值........冇得比 (質素 & 價錢都係).......

Where can I buy the Five-Stars parts and how much does it cost ?

Thanks.

歡迎光臨 RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區 (https://jk.rc-evo.com/xbbs/)