RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區

標題: Want to buy 10.5T motor for TA05 IFS [打印本頁]

作者: ThomasKwok 時間: 2012-10-5 16:18
標題: Want to buy 10.5T motor for TA05 IFS
I use HW 5.5T motor with HW 60A ESC.
I want to change it to 10.5T / 8.5T motor.
Could you please kindly advise which brand and model of motor is better?

Many thanks

作者: Allan007 時間: 2012-10-5 16:31
LRP X20 is the best.

作者: ThomasKwok 時間: 2012-10-5 16:50
how many T is good for my car and ESC (HW 60A) ?

作者: s.y.kwok 時間: 2012-10-5 17:04

ThomasKwok 發表於 2012-10-5 16:50

登錄/註冊後可看大圖

how many T is good for my car and ESC (HW 60A) ?

60A prefer 13.5T or higher.

作者: ThomasKwok 時間: 2012-10-5 17:10

Allan007 發表於 2012-10-5 16:31

登錄/註冊後可看大圖

LRP X20 is the best.

It seems expensive ~_~

作者: ThomasKwok 時間: 2012-10-5 17:12

s.y.kwok 發表於 2012-10-5 17:04

登錄/註冊後可看大圖

60A prefer 13.5T or higher.

10.5T and 8.5T ok ma?
May I use non HW motor?
Which brand and model is around $300?

作者: s.y.kwok 時間: 2012-10-5 18:28

ThomasKwok 發表於 2012-10-5 17:12

登錄/註冊後可看大圖

10.5T and 8.5T ok ma?
May I use non HW motor?
Which brand and model is around $300?

唔係唔用得,
不過用turbo的話有機會overload cut.
用任何牌子嘅摩打都okay嘅,
300左右舊版tp都okay嘅

作者: defcone 時間: 2012-10-5 18:42
10.5t + 60a with boost ok, 我之前無風扇玩8分鐘比賽電變都唔過40度. 300幾蚊SP V3 not bad.

作者: ThomasKwok 時間: 2012-10-5 22:20

defcone 發表於 2012-10-5 18:42

登錄/註冊後可看大圖

10.5t + 60a with boost ok, 我之前無風扇玩8分鐘比賽電變都唔過40度. 300幾蚊SP V3 not bad. ...

Thanks
SP V3 有無turbo?

作者: s.y.kwok 時間: 2012-10-5 22:49

defcone 發表於 2012-10-5 18:42

登錄/註冊後可看大圖

10.5t + 60a with boost ok, 我之前無風扇玩8分鐘比賽電變都唔過40度. 300幾蚊SP V3 not bad. ...

我用120A 10.5T,
晚上氣溫28度,
8分鐘.
電變都錄得最高72度.....

作者: s.y.kwok 時間: 2012-10-5 22:51

ThomasKwok 發表於 2012-10-5 22:20

登錄/註冊後可看大圖

Thanks
SP V3 有無turbo?

係有感,
如果你個電變有turbo就有喇

作者: Noir.KAZE 時間: 2012-10-5 23:30

s.y.kwok 發表於 2012-10-5 22:49

登錄/註冊後可看大圖

我用120A 10.5T,
晚上氣溫28度,
8分鐘.

你架車太快啦XD

作者: s.y.kwok 時間: 2012-10-5 23:54

Noir.KAZE 發表於 2012-10-5 23:30

登錄/註冊後可看大圖

你架車太快啦XD

齒比6.65
boost 15
2000/2500start
10000end
turbo 18
t sloop 24
正常車速咋

作者: Noir.KAZE 時間: 2012-10-6 00:19

s.y.kwok 發表於 2012-10-5 23:54

登錄/註冊後可看大圖

齒比6.65
boost 15
2000/2500start

我諗緊我係咪熄boost熄得太遲

作者: s.y.kwok 時間: 2012-10-6 00:39

Noir.KAZE 發表於 2012-10-6 00:19

登錄/註冊後可看大圖

我諗緊我係咪熄boost熄得太遲

我計番出黎aac係500

作者: Noir.KAZE 時間: 2012-10-6 00:55

s.y.kwok 發表於 2012-10-6 00:39

登錄/註冊後可看大圖

我計番出黎aac係500

我唔明呢d ga=.="

作者: defcone 時間: 2012-10-6 01:40
本帖最後由 defcone 於 2012-10-6 01:41 編輯

s.y.kwok 發表於 2012-10-5 23:54

登錄/註冊後可看大圖

齒比6.65
boost 15
2000/2500start

What brand motor?

Last time I used Sp 2.1 esc, dualsky z5 10.5t

7.5fdr

40 boost, 5k start rpm, 250ACC

24 Turbo, 24 ramp, delay off

play for around 10 minutes at JV no problem, but this was at Autumn.

作者: s.y.kwok 時間: 2012-10-6 02:55

defcone 發表於 2012-10-6 01:40

登錄/註冊後可看大圖

What brand motor?

Last time I used Sp 2.1 esc, dualsky z5 10.5t

motor is LRP X20,
HW V3 esc,
6.65FDR
10 % drag dreak

作者: 870110a 時間: 2012-10-6 07:16

s.y.kwok 發表於 2012-10-6 00:39

登錄/註冊後可看大圖

我計番出黎aac係500

我想問係點計acc? Thx

作者: defcone 時間: 2012-10-6 09:28

870110a 發表於 2012-10-6 07:16

登錄/註冊後可看大圖

我想問係點計acc? Thx

(End Rpm - Start Rpm) / Boost

作者: 870110a 時間: 2012-10-6 10:58

defcone 發表於 2012-10-6 09:28

登錄/註冊後可看大圖

(End Rpm - Start Rpm) / Boost

Thx ching

作者: tsfai 時間: 2012-10-6 13:51

s.y.kwok 發表於 2012-10-5 23:54
齒比6.65
boost 15
2000/2500start

Ching,
I have HW extrem stock 60a. Is this esc no end rmp set for boost?

作者: s.y.kwok 時間: 2012-10-6 15:06

tsfai 發表於 2012-10-6 13:51

登錄/註冊後可看大圖

Ching,
I have HW extrem stock 60a. Is this esc no end rmp set for boost?

yes,
than no need to set "end rpm"

作者: tsfai 時間: 2012-10-6 18:16

s.y.kwok 發表於 2012-10-6 15:06
yes,
than no need to set "end rpm"

Thanks ching.
Can you suggest turbo and boost setting for new hand in jv? I use ss0 and tp 9.5t. Current FDR is 6.69.

作者: s.y.kwok 時間: 2012-10-6 18:30
本帖最後由 s.y.kwok 於 2012-10-6 18:41 編輯

tsfai 發表於 2012-10-6 18:16

登錄/註冊後可看大圖

Thanks ching.
Can you suggest turbo and boost setting for new hand in jv? I use ss0 and tp 9.5t. ...

what brand of motor u using??
coz of they hv difference characteristics.
u can try 20 boost 18 turbo first.
run 2mins,check it temperature.
if lower than 60degree.than run 5 mins more.than check
better keep it below 80 degree finally after run 8 mins(a pack of battery)
if u find it not fast enough for u.
add the value by 2 every time either boost/turbo
(boost for acceleration.turbo for top speed).
and repeat to check the temperature again

by the way,i dun prefer the new hand concent about "speed" first.
better keep it no boost/turbo b4 u got the right setting,right grip & racing line.
hope can help

作者: tsfai 時間: 2012-10-6 22:51
Appreciate and agree SY ching.
I started with HW EZrun 60a + 8.5T sensorless 3 months ago. I used 19T pinion gear initially and increased one T when I felt I could get control of the car reaching 23T now.
I am trying different settings, tires and to manage to stay in the same running line, which was difficult initially and still sounds a bit challenge now. I keep learning.

Now I just bought the Extreme stock esc + team power 9.5T(old version) and will try your suggestion as a start. Thanks again.

Hope to meet you in JV and learn more.

作者: s.y.kwok 時間: 2012-10-6 23:47

tsfai 發表於 2012-10-6 22:51

登錄/註冊後可看大圖

Appreciate and agree SY ching.
I started with HW EZrun 60a + 8.5T sensorless 3 months ago. I used 19 ...

just a suggestion to make your race more efficiency.
not teaching.i'm just a player,too
in my experience,accurate racing line can make faster lap time than higher speed of the car does.
all of my "rc mate" @ jv are playing with 10.5T motor only.
hope can meet u at jv & play together

作者: tsfai 時間: 2012-10-7 11:07

s.y.kwok 發表於 2012-10-6 23:47
just a suggestion to make your race more efficiency.
not teaching.i'm just a player,too
in my expe ...

Yes, ching. Still a lot to learn and play for great fun.

歡迎光臨 RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區 (https://jk.rc-evo.com/xbbs/)