RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區

標題: ~~~充電問題~~~ 急-!! [打印本頁]

作者: 76人‧小狂 時間: 2006-11-14 19:49
標題: ~~~充電問題~~~ 急-!!
有冇師兄知道用 Much-More Racing-Cell Master 叉GP 4300，SANYO 3600，IB 4200要點set??

我叉IB 3600就正常，叉倒3800，
但呢三隻電就點叉都係得果千幾......
有好多排......趕住嫁...
希望大家指教...thx~

作者: zoozoo 時間: 2006-11-14 20:16
Much-More Racing-Cell Master 未用过，你调佐几大MV/C啊？一般调到5就够啦，电流用4A左右，仲有就系你调佐温度到几大就会停充？我试过一次调低佐个温度充唔入电仲以为旧电死佐

作者: 76人‧小狂 時間: 2006-11-14 20:18
MV/C係咩ar???

作者: 007 時間: 2006-11-14 20:23
mV refers to the delta cut off setting. Set it to 24mV. If it cuts too early, change it to 30mV. You need to review the manual. If you don't have one, download it from Much More's site.

作者: 76人‧小狂 時間: 2006-11-14 20:28

原帖由 007 於 2006-11-14 20:23 發表
mV refers to the delta cut off setting. Set it to 24mV. If it cuts too early, change it to 30mV. You need to review the manual. If you don't have one, download it from Much More's site.

我set左係6mV lor...有冇錯呢???
說明書好多都係set做3mV咋bor~
仲要set多d牙...

作者: 中遠 時間: 2006-11-14 21:20
唔理幾多，照差就得。。。

作者: 007 時間: 2006-11-15 18:13
No need to follow 3mV stated in the manual. It is too low. 3mV in Cell Master refers to the whole pack e.g. 6 cells. No one will set 3mV for 6 cells, too easy to cut off.

作者: 毒魚 時間: 2006-11-15 18:18
你差個mah有調到上4200mah以上咩= ="

用24mv highcut好像比較易overchange,電易死些的

歡迎光臨 RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區 (https://jk.rc-evo.com/xbbs/)