1. Add the reminder for customer to update LCD firmware disconnecting ESC.
2. Improve performance of update firmware.
3. Release LCD Program Card firmware V2.6 (See LCD program card release note)
Reminder:
LED programmer card users will not be able to access the new custom settings.
LED users must upgrade to the LCD program card to access the new custom settings.
Recommendation:
Please run standalone PC Interface on ESC / Program Card firmware update.
Other process may affect the updating process screen.作者: rcpop 時間: 2012-12-10 11:32
kkchung...多謝你提供..
但我有個問題..我隻摩打本身無得調較進角的,用STOCK1 PROGRAM 全部推到最大先能夠有turbo...
是否正常...13.5 同 10.5 一樣...