RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區

標題: 1/8 buggy motor running temp ? [打印本頁]

作者: alex1030    時間: 2013-3-13 11:05
標題: 1/8 buggy motor running temp ?
本帖最後由 alex1030 於 2013-3-13 11:51 編輯

Hello everyone, I am a beginner of 1/8 buggy. I have got a HW 150A combo. I installed it into an Xray 808E with 13T pinion running 4s battery, the motor temp seems to be very very high after running. What is the normal temp for a 1/8 electric motor after a run?


作者: ftbingobingo    時間: 2013-3-13 17:34
Please show the picture of your motor
作者: fr888    時間: 2013-3-13 21:00
Best below 80 deg C
作者: alex1030    時間: 2013-3-14 07:29
ftbingobingo 發表於 2013-3-13 17:34
Please show the picture of your motor

Thank you c hing, I am using a hobbywing 4068 motor.
作者: alex1030    時間: 2013-3-14 07:30
fr888 發表於 2013-3-13 21:00
Best below 80 deg C

I will use temp gun to test it. BTW, do you use motor fan to cool it off? My motor diameter is 40mm, any recommendation?
作者: ftbingobingo    時間: 2013-3-14 19:31
Go lower the punch and the timing of the ESC, the normal temp of motor is around 70-80
作者: alex1030    時間: 2013-3-14 19:40
ftbingobingo 發表於 2013-3-14 19:31
Go lower the punch and the timing of the ESC, the normal temp of motor is around 70-80

Thank you C hing, I will turn down the timing.
作者: 680086    時間: 2013-3-14 22:24
alex1030 發表於 2013-3-14 07:30
I will use temp gun to test it. BTW, do you use motor fan to cool it off? My motor diameter is 40m ...

http://www.rcmart.com/yeah-racin ... .html?cPath=1560_32
作者: fr888    時間: 2013-3-15 01:11
alex1030 發表於 2013-3-14 07:30
I will use temp gun to test it. BTW, do you use motor fan to cool it off? My motor diameter is 40m ...

i dont use fan in 1:8, proper gearing and esc setting should make the motor temp in good range...
作者: 965    時間: 2013-3-21 02:14
Hot (warm) is ok, not boiling hot ... (Your hand can still touch and hold it)

13T still be very safe with 4s on 808 ...




歡迎光臨 RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區 (https://jk.rc-evo.com/xbbs/) Powered by Discuz! X3.2