RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區

標題: 請問有冇C兄把大Summit換大D摩打 [打印本頁]

作者: jackyrc 時間: 2013-5-15 12:05
標題: 請問有冇C兄把大Summit換大D摩打
本帖最後由 jackyrc 於 2013-5-15 12:07 編輯

請問有冇C兄把大Summit換大D摩打

作者: Htse 時間: 2013-5-15 15:36
u can change it to a dewalt drill motor. if u go brushless u need to get a sensored system or it will cog like crazy(cog is the cogging motion of a motor, not center of gravity which some ching made up, center of gravity is call cg) i had mine brushless and flipping every corner, end up using stock esc with dewalt motor. tons of power added from the stock u should give it a try.

作者: DLAM 時間: 2013-5-15 16:13

Htse 發表於 2013-5-15 15:36
u can change it to a dewalt drill motor. if u go brushless u need to get a sensored system or it wil ...

Ching, may I know what is dewalt drill motor? And where to get it?

many thanks

作者: Htse 時間: 2013-5-15 16:37

DLAM 發表於 2013-5-15 16:13

登錄/註冊後可看大圖

Ching, may I know what is dewalt drill motor? And where to get it?

many thanks

Dewalt 電鑽 motor, get it from ebay or maybe some hardware store carries them i dont know i got mine from ebay search "14.4v dewalt motor" on ebay very low cost but increase speed, torque on ur summit by A LOT(and cost around 30usd), but u need to solder the wire correctly to get it work, it is very simple, just move the wires from ur old motor to the dewalt one! i ran it in water without problem as well! good luck!

作者: RGear 時間: 2013-5-15 17:01
Details pls see video
http://www.youtube.com/watch?v=ZrxSYmzAMEY

作者: 965 時間: 2013-5-20 14:54
Can consider low kv brushless and run 6s .... Like 1200-1600 area....

作者: Htse 時間: 2013-5-21 10:40

965 發表於 2013-5-20 14:54
Can consider low kv brushless and run 6s .... Like 1200-1600 area....

If u like to flip ur car every 5sec. And then it has to be sensored therefore not waterproof anymore.

歡迎光臨 RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區 (https://jk.rc-evo.com/xbbs/)