標題: traxxas slash 4x4 摩打齒請教 [打印本頁] 作者: jackyrc 時間: 2013-5-19 00:04 標題: traxxas slash 4x4 摩打齒請教 traxxas slash 4x4 原裝摩打用 9.9V(a123)電 用幾多摩打齒.thx!
原裝摩打用8.4v電 用18t摩打齒可以嗎.thx! (我用了後摩打好熱) 作者: jackyrc 時間: 2013-5-19 00:09
ip 9.9v 25c 2000mah作者: 鬼謎 時間: 2013-5-19 00:41
我都有玩,熱係正常,我玩3s 5500 60c 電都無事,架車玩左半年了。作者: Htse 時間: 2013-5-19 00:42
add a fan and see how it goes, if still too hot then u should work ur pinion down or u WILL damage ur motor作者: 965 時間: 2013-5-19 23:44 本帖最後由 965 於 2013-5-20 14:50 編輯
18t ... Bit high.... Not enough torque ga... Try 16t la....I think I use 14 or 15 with 3s... But pain in the butts to change pin....
LiFe is good idea, but 2000mah may be a bit small... U could probably stack them together to run parallel ...作者: edwardkmlau 時間: 2013-5-20 00:17
18T真係太高喎, 我用15T+3cell LiFe都幾快下囉喎