RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區

標題: 差電的苦惱 [打印本頁]

作者: rcevo668    時間: 2013-11-20 01:46
標題: 差電的苦惱
請教各位師兄,請問差lipo 7.4V 2S電應該/几多A去充才可以充满舊電
作者: TOMY1988    時間: 2013-11-20 02:16

幾多mah???

4000 用4a

5000用5a.   .......

作者: arepei2002    時間: 2013-11-20 07:54
用 10 A  爆啲 傷啲
作者: Tam    時間: 2013-11-20 08:03
5a 差5000mah 45min 至 1hr
作者: kennywch    時間: 2013-11-20 09:28
師兄,你差5000mah 45min 請問你用什麼差機?
作者: G2偉    時間: 2013-11-20 11:16
唔洗咁耐既
作者: carrc    時間: 2013-11-20 11:44
為何通帶充到最尾就會降致0.1A充?
整到我5500mah(5.5A充)用180min左右先完成?
作者: hungbobby    時間: 2013-11-20 13:34
The time required to fully charge any battery depends on several factors including the total capacity of the battery, the remaining capacity on the battery, the charge rate and also the charge method of the charger. For most balance charger, it will automatically adjust to a lower charge rate when approaching the upper charge voltage limit, to avoid overcharging the battery. But as a lower charge rate is used, it will then extend the time required to reach the upper voltage limit. You may choose fast charge mode if available on your charger, which will stop charging when it is approaching the upper voltage limit, but your battery may not be fully charged.
作者: Tam    時間: 2013-11-20 20:44
kennywch 發表於 2013-11-20 09:28
師兄,你差5000mah 45min 請問你用什麼差機?

B6. 放到3.4v esc cut 油。 唔放盡,45min ok
放盡要1hr 多d

作者: Tam    時間: 2013-11-20 20:55
carrc 發表於 2013-11-20 11:44
為何通帶充到最尾就會降致0.1A充?
整到我5500mah(5.5A充)用180min左右先完成?

排電唔平行,充到尾,差機要做平行。要用好多時間,一係排電質量有問題,一係排電試過過放。使兩個cell 有不平行損毀。你可試一下差到尾時,改用一cell, 只差電壓較底的一cell. 會快d.  如幾排電有相同問題。可能差機平行死了




歡迎光臨 RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區 (https://jk.rc-evo.com/xbbs/) Powered by Discuz! X3.2