作者: tsehu 時間: 2014-9-3 23:19
I had the same problem, and the below worked for me:
To reset the transmitter:
(1) Turn off the transmitter if it is on.
(2) Make sure that the steering trim knob is at the center position
(3) Turn the G.SPD L knob fully to the counterclockwise direction.
(4) Position of G.SPD H knob does not matter.
(5) Turn the steering wheel to the fully right position and push the throttle away to the full-brake position and hold them.
(6) Turn on the transmitter. The LED should flash rapidly; this means you are now in the factory mode.
(7) Release the steering wheel and throttle lever.
(8) Turn the steering wheel fully to the left, right, left and right, and then release it.
(9) Pull/push the throttle lever to full-throttle, full-brake, full-throttle, and full-brake, and then release it.
(10) Turn the G.SPD L knob to the right most position. The LED should become solid.
(11) Turn off the transmitter and on it again. You are done.作者: ray2011 時間: 2014-9-4 09:23
上MMS車場揾幫忙!作者: ming1983 時間: 2014-9-4 20:31 Mini-Z Sports 系列簡易故障排除
問題已解決～thz 各位
