RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區

標題: question in brushless system [打印本頁]

作者: gibson 時間: 2007-2-6 01:45
標題: question in brushless system
I just finished reset the novak 4.5r brushless system, when neutral, the red, green and amber leds are all on. Is it normal? Thanks

登錄/註冊後可看大圖

[ 本帖最後由 gibson 於 2007-2-6 01:47 編輯 ]

作者: 007 時間: 2007-2-6 12:03
If you use drag break setting, two lights will be on which is normal, not just one light as stated in the manual. But I don't remember which colour should be on at this moment.

作者: gibson 時間: 2007-2-6 12:15

原帖由 007 於 2007-2-6 12:03 發表
If you use drag break setting, two lights will be on which is normal, not just one light as stated in the manual. But I don't remember which colour should be on at this moment.

I had read all the manual but did not mention about the lights wor...

作者: 007 時間: 2007-2-6 12:20
Gibson, see the flow chart in page 6 of your manual; you will see the light is written inside each box.

作者: gibson 時間: 2007-2-6 12:27

原帖由 007 於 2007-2-6 12:20 發表
Gibson, see the flow chart in page 6 of your manual; you will see the light is written inside each box.

Thanks 007, will check again!!

歡迎光臨 RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區 (https://jk.rc-evo.com/xbbs/)