RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區

標題: TA05R 巳準備好!!!! [打印本頁]

作者: minibiker 時間: 2007-8-22 12:47
標題: TA05R 巳準備好!!!!

可以落地, 不過都幾重下

: 登錄/註冊後可看大圖

作者: AMAT 時間: 2007-8-22 12:50
皮帶有冇刮住個中波箱果個U型散熱?

作者: minibiker 時間: 2007-8-22 12:54
冇呀! 不過排電就hi到, 我貼左塊膠布係果度

可能用Ｄ薄既焊電片會好Ｄ, 個位真係好fit...同埋插頭一定向內

作者: minibiker 時間: 2007-8-22 13:03
紅圈地方貼左黑膠布

唔知Option果件摩打座會否好Ｄ??

: 登錄/註冊後可看大圖

作者: rk2 時間: 2007-8-22 13:19
RED WIRE CONNECTED TO THE MOTOR NEED SHRINKABLE TUBE. OTHERWISE EASY TOUCH OTHER METAL PARTS.

作者: minibiker 時間: 2007-8-22 13:21

原帖由 rk2 於 2007-8-22 13:19 發表

 登錄/註冊後可看大圖

RED WIRE CONNECTED TO THE MOTOR NEED SHRINKABLE TUBE. OTHERWISE EASY TOUCH OTHER METAL PARTS.

Where exactly?

Thanks!

作者: move7648 時間: 2007-8-22 13:26

原帖由 minibiker 於 2007-8-22 01:21 PM 發表

 登錄/註冊後可看大圖

Where exactly? Thanks!

你焊摩打同電池o個個位喎, 你睇唔到??
定係特登架???

作者: rk2 時間: 2007-8-22 13:50

原帖由 minibiker 於 2007-8-22 13:21 發表

 登錄/註冊後可看大圖

Where exactly? Thanks!

出摩打條紅色線, 有銲鍚露出果到, 要包膠紙或用收縮通.

作者: minibiker 時間: 2007-8-22 13:59
get it!!!! thanks
I did wrap it B4...but i took it out, coz doesn't look good!!

作者: GigaRacer 時間: 2007-8-22 14:23
I think the wires from ESC to Motor should not wrap around the rear belt. Just make them shorter, and go to the motor directly.

作者: minibiker 時間: 2007-8-22 14:58

原帖由 GigaRacer 於 2007-8-22 14:23 發表

 登錄/註冊後可看大圖

I think the wires from ESC to Motor should not wrap around the rear belt. Just make them shorter, and go to the motor directly.

The wires was installed by the factory, the direction is not convenience to do that so!!
Or, I need to rewired them all over!

作者: heiman 時間: 2007-8-22 15:41
how much is the ESC?? thx

作者: minibiker 時間: 2007-8-22 16:00
$670

作者: kelvin654 時間: 2007-8-27 17:06
i have 05R also but didnt touch the belt waor

歡迎光臨 RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區 (https://jk.rc-evo.com/xbbs/)