RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區

標題: 點解裝完個Stablizer架車冇咗回彈力??? [打印本頁]

作者: bigben 時間: 2007-9-7 10:51
標題: 點解裝完個Stablizer架車冇咗回彈力???
未裝之前架車壓低咗 (用手"禁"低佢) 都有回彈力(用硬彈弓).....

但點解裝完後架車回彈力弱咗好多???

(借圖一用)

[ 本帖最後由 bigben 於 2007-9-7 10:53 編輯 ]

作者: raymen 時間: 2007-9-7 11:43
Buggy no need that one la.....

*** for 1/10 Touring is ok.

[ 本帖最後由 raymen 於 2007-9-7 12:07 編輯 ]

作者: bigben 時間: 2007-9-7 11:56
i know....
but someone say that it is better for steering and more stable....if the car body is set to be high.....

作者: 師傅東 時間: 2007-9-7 12:03
你架係乜車嚟先？

作者: i-Drift 時間: 2007-9-7 12:31
Have you tightened the hex screws for holding the bar in place?

作者: bigben 時間: 2007-9-7 13:02
你架係乜車嚟先？ ------- Kyosho GP buggy

Have you tightened the hex screws for holding the bar in place? ------ Yes

作者: i-Drift 時間: 2007-9-7 13:05
It could be the angle or the bar is too stiff. So the car cannot bounce back.

作者: i-Drift 時間: 2007-9-7 13:08
After you pushed the car down, the car stuck at that position and won't bounce back.

But if you use a finger to slightly push the car upward, at certain point, the car will bounce suddenly. Then the Bar is not set properly.

Try adjusting the 2 bar holders (at the end of the bar) slightly and try again.

作者: bigben 時間: 2007-9-7 13:17

原帖由 i-Drift 於 2007-9-7 13:08 發表

 登錄/註冊後可看大圖

After you pushed the car down, the car stuck at that position and won't bounce back.

But if you use a finger to slightly push the car upward, at certain point, the car will bounce suddenly. T ...

how to adjust.....

??

actually, I tighted the hex screws when the four wheels are off the ground..... is it correct?

作者: vigor 時間: 2007-9-7 22:00

原帖由 bigben 於 2007-9-7 13:17 發表

 登錄/註冊後可看大圖

how to adjust..... ??

actually, I tighted the hex screws when the four wheels are off the ground..... is it correct?

The mount that holds the anti roll bar should be adjusted so that the whole suspension falls freely without the shocks installed. Remove the shocks from the lower suspension arms, and adjust the set screws that hold the anti roll bar.

歡迎光臨 RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區 (https://jk.rc-evo.com/xbbs/)