RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區

標題: Question about buggy wheel [打印本頁]

作者: Brushless 時間: 2007-10-9 14:36
標題: Question about buggy wheel
When my lazer accelerates, the tyres deform a bit (bulging out) as expected because of centrifrigal force. However, when the car slows down, one of the tyres fail to change into its original appearance, it keeps on inflated. I think it is probably due to non-ideal glueing. So when the car accelerate, air goes in, but fails to come out during deceleration as air is trapped with the non ideal glued tyre acts like a one way valve.

Should I solve the problem by drilling some holes on the inner surface of the wheel(all the wheels)?

作者: mikewu 時間: 2007-10-9 14:49

原帖由 Brushless 於 2007-10-9 14:36 發表

 登錄/註冊後可看大圖

When my lazer accelerates, the tyres deform a bit (bulging out) as expected because of centrifrigal force. However, when the car slows down, one of the tyres fail to change into its original appearanc ...

Yes, you can punch a few holes with a screw driver and it should solve the problem.... At least that's what I did with my GP 1/8 truggies....

作者: 師傅東 時間: 2007-10-9 19:57
Mike兄都講得啱！但我就响呔面開孔，因為俾油條呔發張時，帶泥粉嘅空氣會响呤內嘅孔被索入去，唔駛三兩轉就感覺到o架嘞！

作者: joho 時間: 2007-10-11 10:56
The holes are a must! You have two way on doing this either you drill a hole on the tyre, or you can drill them on the rims.
Infact, if you really have to be picky, the size of this "air-holes" will actually affect the performance of the tyres....

作者: 龍崗小吳 時間: 2007-10-11 12:07
其實，輪框內的透氣孔的大小相當關鍵，
你可以試著開大一點的孔(並非開在輪胎上)
正式比賽上，孔的大小還有規範喔！
還不能開太大孔，算違規！

作者: Brushless 時間: 2007-10-11 16:17
thank you everybody

歡迎光臨 RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區 (https://jk.rc-evo.com/xbbs/)